Abstract:Ag-based catalysts supported on various metal oxides, Al2O3, TiO2, and TiO2–Al2O3, were prepared by the sol–gel method. The effect of SO2 on catalytic activity was investigated for NO reduction with propene under lean burn condition. The results showed the catalytic activities were greatly enhanced on Ag/TiO2–Al2O3 in comparison to Ag/Al2O3 and Ag/TiO2, especially in the low temperature region. Application of different characterization techniques revealed that the activity enhancement was correlated with the properties of the support material. Silver was highly dispersed over the amorphous system of TiO2–Al2O3. NO3− rather than NO2− or NOx reacted with the carboxylate species to form CN or NCO. NO2 was the predominant desorption species in the temperature programmed desorption (TPD) of NO on Ag/TiO2–Al2O3. More amount of formate (HCOO−) and CN were generated on the Ag/TiO2–Al2O3 catalyst than the Ag/Al2O3 catalyst, due to an increased number of Lewis acid sites. Sulfate species, resulted from SO2 oxidation, played dual roles on catalytic activity. On aged samples, the slow decomposition of accumulated sulfate species on catalyst surface led to poor NO conversion due to the blockage of these species on active sites. On the other hand, catalytic activity was greatly enhanced in the low temperature region because of the enhanced intensity of Lewis acid site caused by the adsorbed sulfate species. The rate of sulfate accumulation on the Ag/TiO2–Al2O3 system was relatively slow. As a consequence, the system showed superior capability for selective adsorption of NO and SO2 toleration to the Ag/Al2O3 catalyst.

Research and application of the catalyst assemblies for NOx selective catalytic reduction by ethanol

The development of Fe2O3-based catalysts used for the selective catalytic reduction of NOx with NH3: A review

An Ethanol SCR for NOx Purification: Performance Evaluation on Engine Bench and Demonstration on Bus

Catalytic performance of Ag/Al2O3-C2H5OH-Cu/Al2O3 system for the removal of NOx from diesel engine exhaust.

Application of Nox-SCR Aftertreatment System to the HD Diesel Engine Using Ethanol As a Reductant

Performance Evaluation and Application of Diesel NOx-SCR Catalyst by Ethanol Reductant

Tailoring the Proceeding of the NH3-SCO and NH3-SCR Reactions over FeOx Catalysts by Modifying with NbOx

Selective Catalytic Reduction of NO X from Exhaust of Lean-Burn Engine over Ag-Al 2 O 3 /cordierite Catalyst

Selective Catalytic Reduction of NO_x on Ag/Al_2O_3 Catalyst in Lean-Burn Gasoline Engines

In Situ DRIFTS Studies of NH3-SCR Mechanism over V2O5-CeO2/TiO2-ZrO2 Catalysts for Selective Catalytic Reduction of NOx

Application of the Ag/Al2O3 catalyst in the selectively catalytic reduction of NO by hydrocarbons

Promotion effect of H2 on ethanol oxidation and NOx reduction with ethanol over Ag/Al2O3 catalyst

Preparation of Ag/ Al2O3 Selective Catalytic Reduction Monolithic Catalyst

γ-Al2O3 supported silver nanoparticle applied in C3H8-SCR: Nanosphere and nanoflake

Combination of Biodiesel-Ethanol-diesel Fuel Blend and SCR Catalyst Assembly to Reduce Emissions from a Heavy-Duty Diesel Engine.

[Alumina-Supported Catalysts for the Catalytic Purification of Lean-Burn Automobile Exhaust].

Catalytic removal of nitrogen oxides for the lean-burn automobile exhaust

High Efficiency of Noble Metal and Metal Oxide Catalyst Systems for the Selective Reduction of NO with Propene in Lean Exhaust Gas

Influence of preparation methods on selective catalytic reduction of nitric oxides by propene over silver–alumina catalyst

SELECTIVE REDUCTION DENITRIFICATION OF FLUE GAS BY USING CATALYST Ag/Al2O3 AND REDUCING AGENT C3H6

Improvement of Catalytic Activity and Sulfur-Resistance of Ag/TiO2–Al2O3 for NO Reduction with Propene under Lean Burn Conditions