Abstract:In this study, an exhaust system compliant with future regulations was developed for a non-road 110PS engine with a Tier-4f aftertreatment system, and the emission characteristics of the engine were investigated in the non-road transient mode (NRTC). For the system to comply with future exhaust regulations, a DPF was installed, and an electrical heated catalyst (EHC) device was installed to manage exhaust gas temperature. The emission characteristics of exhaust gas were examined according to the power and applied duration of EHC, and the effects of catalyst coating and the urea water solution (UWS) injection map on NOx reduction, NH3 slip, and N2O emissions in NRTC mode were investigated. The application of a 4 kW class EHC system enables the lowering of the injection starting temperature of the UWS, as reliable gas heating (heating duration control) is guaranteed. When the injection starting temperature (based on the SCR inlet temperature) was set to 150 °C, NSR map, (III) in conjunction with the operation of the EHC, effectively achieved significant NOx reduction in NRTC mode without deposit and wetting occurring in the mixer and exhaust pipe. Regarding changes in EHC power from 3 kW to 4 kW, it was observed that a NOx reduction of 0.05 g/kWh occurs in the cold NRTC mode, but in the hot NRTC mode, it was found that the relative decrease in the UWS is due to the increased NO2 conversion efficiency as a result of the oxidation catalyst, making 3 kW more advantageous. Furthermore, due to the increase in NO2 concentration caused by the oxidation catalyst and the increase in the low-temperature injected UWS, NH4NO3 was formed, which resulted in an increase in PM emissions and a significant increase in N2O emissions around an exhaust temperature of 250 °C. When the EHC power was set to 3 kW and the volume of oxidation catalyst and the amount of UWS injection were adjusted, applying EHC in the NRTC mode resulted in an additional NOx reduction of 58.6% and 88.4% in cold and hot modes, respectively, compared with not using EHC, with a fuel penalty of approximately 1.67%, while limiting the peak concentrations of N2O and NH3.

An Ethanol SCR for NOx Purification: Performance Evaluation on Engine Bench and Demonstration on Bus

Performance Evaluation and Application of Diesel NOx-SCR Catalyst by Ethanol Reductant

Application of Nox-SCR Aftertreatment System to the HD Diesel Engine Using Ethanol As a Reductant

Research and application of the catalyst assemblies for NOx selective catalytic reduction by ethanol

Catalytic performance of Ag/Al2O3-C2H5OH-Cu/Al2O3 system for the removal of NOx from diesel engine exhaust.

Combination of Biodiesel-Ethanol-diesel Fuel Blend and SCR Catalyst Assembly to Reduce Emissions from a Heavy-Duty Diesel Engine.

Selective Catalytic Reduction of NO X from Exhaust of Lean-Burn Engine over Ag-Al 2 O 3 /cordierite Catalyst

Fuel Consumption and Emission Reduction for Non-Road Diesel Engines with Electrically Heated Catalysts

Experimental demonstration of NOx reduction and ammonia slip for diesel engine SCR system

Experimental demonstration of NO x reduction and ammonia slip for diesel engine SCR system

Selective Catalytic Reduction of NO_x on Ag/Al_2O_3 Catalyst in Lean-Burn Gasoline Engines

Experimental Demonstration of NO Reduction and Ammonia Slip for Diesel Engine SCR System

Review on Selective Catalytic Reduction Technology of Diesel Engines

Experiment Study of the Modification of γ/Al203 Catalyst on Methanol-SCR of NO

Selective Catalytic Reduction of Nitrogen Oxides with Methanol over the (Cobalt-Molybdenum)/alumina Dual Catalysts under the Diesel Methanol Dual Fuel Exhaust Conditions

NOx Emission Removal from a Parallel Diesel Engine Group by SCR System Based on Distributed Control Technology

Performance Evaluation of the Lean NOx Catalyst for Diesel Engine

Optimization Analysis of Various Parameters Based on Response Surface Methodology for Enhancing NOx Catalytic Reduction Performance of Urea Selective Catalytic Reduction on Cu-ZSM-13 Catalyst

Effect of Ammonia on the Intermediates and Chemical Pathway of Selective Catalytic Reduction of NO by Ethanol over a Pt/Al2O3 Catalyst

Study on Development of a Urea-SCR System of Diesel Engine

Study On The Preparation And Performance Properties Of Scr Deno(X) Catalyst