Abstract:A novel metallic monolith anodic γ-alumina catalyst, prepared through anodization of aluminum, hot water treatment and active metal impregnation, was employed to investigate the selective catalytic reduction of NO under oxygen-rich conditions with propene and diesel fuel as reducing agents.Using propene as a reducing agent, Pt/Al2O3/Al offered the best low-temperature SCR activity (about 573 K), and was resistant to SO2 poisoning. However, a high undesired selectivity to N2O and a narrow operating-temperature window were two major disadvantages. At a moderate temperature (about 673 K), Cu-Ce/Al2O3/Al showed a favorable de-NOx activity comparable to Pt/Al2O3/Al, a higher N2 selectivity and a wider operating-temperature window than Pt/Al2O3/Al. In particular, adding SO2 into feedstream dramatically promoted the de-NOx activity of Cu-Ce/Al2O3/Al, and this increase was unchanged with time-on-stream. Among the catalysts tested in this paper, the highest de-NOx activity was obtained on the alumite support, but at a high temperature (about 773 K). Although the presence of SO2 strongly inhibited the NOx reduction of the alumite support, NOx conversion of 80% could still be maintained in the coexisting SO2 and H2O.When introducing diesel fuel instead of propene as a reducing agent, the over-oxidation of diesel fuel by oxygen remarkably decreased the NOx reduction of Pt/Al2O3/Al and Cu-Ce/Al2O3/Al. The alumite support became a promising choice, due to the stable 67% of de-NOx activity achieved under the same redox conditions. However, the presence of a high concentration of SO2 substantially depressed the de-NOx activity of the alumite support. On the contrary, a significant promotional effect of SO2 on the de-NOx activity was also observed over Cu-Ce/Al2O3/Al, when using diesel fuel as a reducing agent, as observed in the SCR-NO-C3H6.

[Alumina-Supported Catalysts for the Catalytic Purification of Lean-Burn Automobile Exhaust].

Catalytic removal of nitrogen oxides for the lean-burn automobile exhaust

Selective Catalytic Reduction of NO X from Exhaust of Lean-Burn Engine over Ag-Al 2 O 3 /cordierite Catalyst

Preparation of Alumite Support and Preliminary Activity Investigation for NO Removal in SCR-HC over Alumite Catalyst

A Comparative Study of Ag/Al2O3 and Cu/Al2O3 Catalysts for the Selective Catalytic Reduction of NO by C3H6

Preparation of Ag/ Al2O3 Selective Catalytic Reduction Monolithic Catalyst

High Efficiency of Noble Metal and Metal Oxide Catalyst Systems for the Selective Reduction of NO with Propene in Lean Exhaust Gas

Cooperation of Pt/Al2O3 and In/Al2O3 Catalysts for NO Reduction by Propene in Lean Burn Condition

Catalytic performance of Ag/Al2O3-C2H5OH-Cu/Al2O3 system for the removal of NOx from diesel engine exhaust.

Selective Catalytic Reduction of NO_x on Ag/Al_2O_3 Catalyst in Lean-Burn Gasoline Engines

Selective Catalytic Reduction of Nitric Oxide with Propene and Diesel Fuel as Reducing Agents over Anodic Alumina Catalyst

Cooperation of Ag/Al2O3 and Sn/Al2O3 Catalysts for the Selective Reduction of NO by Propene

Two-stage catalytic system of Sn/Al2O3 and Pt/Al2O3for NO reduction by propene in lean conditions

Preparation of Pt-Pd/BaO/TiAlO catalyst for NOx storage-reduction and its sulfur resistance

Two-stage Catalytic System of Sn/Al2O3and Pt/Al2O3for NO Reduction by Propene in Lean Conditions

Preparation of Pt-Pd/BaO/TiAlO Catalyst for NO_x Storage-Reduction and Its Sulfur Resistance

[Selective Catalytic Reduction of NO on Ag, Co and Cu/Al2O3 in Excess Oxygen].

Improvement of Catalytic Activity and Sulfur-Resistance of Ag/TiO2–Al2O3 for NO Reduction with Propene under Lean Burn Conditions

The Activity and Characterization of Sol-Gel Sn/Al2o3 Catalyst for Selective Catalytic Reduction of Nox in the Presence of Oxygen

Influence of preparation methods on selective catalytic reduction of nitric oxides by propene over silver–alumina catalyst

Selective Catalytic Reduction of NO in Diesel Exhaust over Anodic Alumina Catalyst