Abstract:Crack behavior of aluminum alloy 2A12-T4 is investigated experimentally and numerically using cruciform specimens subjected to in-plane biaxial loadings applied in horizontal (x axis) and vertical (y axis) directions. Different cruciform configuration plans, with variant sizes of slots in loading arms and different transitional fillet radius between adjacent arms, are analyzed by means of FEM to confirm a final specimen geometry with relative uniform stress distribution in its central area. The tests for fatigue crack growth behavior under cyclic biaxial sinusoidal loadings with phase differences of 0 degrees or 60 degrees between two orthogonal fatigue loads are conducted by using a biaxial fatigue test system. The biaxial load ratio, P-max(x)/P-max(y), varies from -0.5 to 1.0. Initial central cracks are inclining in angles of 0 degrees, 45 degrees and 60 degrees to x-axis. Crack growth path and lives are obtained. It is observed that the crack growth behavior under biaxial loading differs from that with only uniaxial loading. A widely accepted fatigue crack growth model, which combines Paris equation, maximum tangential stress (MTS) criterion and an equivalent stress intensity factor (SIF) proposed by Tanaka, is used for mixed mode-I/II crack subjected biaxial loading. The combined model is evaluated by the SIFs analysis based on analytical and numerical solution. The mixed mode SIFs are calculated based on finite element analysis with mesh updating. The simulated crack growth path and growth lives correlate well with the experiments in most cases. Both the experiments and the simulations demonstrate that the tensile load parallel to crack path behaves as the retarder to the crack growth, and the compressive load parallel to crack path behaves as the promoter to the crack growth. It is found that equivalent SIF used in the model overestimates the effect of mode II SIF on the fatigue crack growth rate by Paris equation. It is questionable to use the combined model for the cases with asynchronous biaxial loadings or those leading to crack surface contact.

On the Study of Fatigue Crack Propagation in the Time Domain

Analyses of the fatigue crack propagation process and stress ratio effects using the two parameter method

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Investigative Method for Fatigue Crack Propagation Based on a Small Time Scale.

Analysis of the relationship between Kmax and ΔKth for aluminium alloys

Investigation of Fatigue Crack Growth under Loading Sequence Effects Using In-Situ SEM Testing

Fatigue Crack Initiation and Propagation Behavior of Nickel-Based Single Crystal DD6 under Different Drilling Processes

Application of Strain Energy Based Approach for Evaluation of Fatigue Crack Growth Retardation Effect under Random Overload

A Simple Engineering Approach in the Prediction of the Effect of Stress Ratio on Fatigue Threshold

A Study of the Numerical Simulation Technique for Fatigue Crack Closure

Study on the propagation of 3D fatigue crack initiated from fastener holes

Experimental Research on Fatigue Crack Growth Modes Transition in Near-threshold Regime

Subcycle Fatigue Crack Growth Mechanism Investigation for Aluminum Alloys and Steel

Fatigue Crack Behaviors under Asynchronous Biaxial Loading

Atomistic Simulation of Short Crack Growth in Correlation with Fatigue Indicator Parameter

Direct High Resolution in Situ Sem Observations of Small Fatigue Crack Opening Profiles in the Ultra-Fine Grain Aluminium Alloy

Investigation of Incremental Fatigue Crack Growth Mechanisms Using in Situ SEM Testing

In-situ SEM and Optical Microscopy Testing for Investigation of Fatigue Crack Growth Mechanism under Overload

A shear band decohesion model for small fatigue carck growth in an ultra-fine grain aluminium alloy

Investigation of Fatigue Growth Behavior of an Inclined Crack in Aluminum Alloy Plate

In-Situ SEM Testing for Transient Fatigue Crack Growth Behavior Investigation Subjected to a Single Tensile Overload