Abstract:Purpose – It is aiming at finding tribology performance laws and mechanism of sintering materials, including new materials, which are popular or potential materials of mechanical seals working under water condition with different working parameters, involving load and sliding speed. Design/methodology/approach – Falex-1506 tribo-machine has been used. The upper sample is rotated against the stationary sample below. They are all rings. The samples are WNV2, sintered pressureless bonded; CHV1, graphite-added PLSiC; R, sintered reaction bonded; R2, graphite-added RBSiC, cemented carbide YN6 and graphite MSMG. Twenty kinds of hard/hard and soft/hard pairs were tested under water condition. Then, SEM was used to observe the sliding surface to explain their rubbing mechanism. Findings – Friction coefficients decrease with the load increasing under water lubrication due to water holding by small holes on their surface. But the friction coefficients have no change with the varying of velocity. The hard alloy/sintered silicon carbon pairs may be better choice, where the lowest friction coefficient is only about 0.02, than soft/hard or silicon carbon/silicon carbon pairs under water lubrication, especially under heavy load. Research limitations/implications – The test was carried under load from 89 N (0.7 MPa) to 356 N (2.80 MPa) and sliding velocity from 0.746 to 5.074 m/s where the lubrication is in mixed. Originality/value – The detailed values of frictional coefficients of popular and potential sintered material of mechanical seals working under water lubrication were given by the experimental research which may be helpful for the choice of mechanical seal materials.

Study on material of mechanical seal for high-speed and high-pressure

Experimental Study on Dynamic Sealing Performance under High Pressure and High Speed

High-Temperature And High-Speed Abadable Tester For Abradability Test Of Seal Coatings

High-speed Abrasion Experimental Research of an Abradable Seal Rubber

Analysis and Experimental Study on Friction and Wear Characteristics of Super High-Speed Mechanical Seal

Study on Frictional Performance of Mechanical Seal Spare Material Used for Nuclear Coolant Pump

Design of High-speed Pump Mechanical Seal of Acetic Anhydride Production Line

Study on the technology of combined seal of magnetic fluid seal and mechanical seal

Study on working mechanism and performance of deep groove seal at high temperature and high speed in mixed lubrication

Study on performance optimization of double screw-magnetic fluid combination seal

Magnetic field simulation and experimental investigation of magnetic fluid seal based on rotating shaft

Leakage and wear characteristics of carbon seals for aero-engines

Analytical and Experimental Study of Sealing Behavior at Water and Magnetic Fluid Interface

Control of Leakage Rate in Spiral Groove Mechanical Seal

Experimental study on behavior of mechanical seal with straight-line notches

An Improved Design of Spiral Groove Mechanical Seal

Pressure Resistance Performance Analysis of High Viscous and Non-Newtonian Magnetic Fluid Sealing

On Frictional Performance of Sintering Materials Used by Mechanical Seals in Water

Experiment and Simulation on the Ferrofluid Boundary Deformation and Fluctuation Characters of a High-Speed Rotary Seal

A comparative study of magnetic seals by ferrofluids, magnetorheological fluids and magnetic powders

Advance in the investigation of brush seal