Abstract:This paper concerns high-power laser welding of thick plates for the ship industry. Thermomechanical behavior during laser welding of 16-mm marine steel EH40 using 25-kW laser power was investigated by a 3D finite element model. The objective is to analyze the effects of weld collapse and hump on the residual stress-induced thermal cycle. A double-cylindrical source model was proposed to simulate the transient distribution of temperature field. Heat flow distribution area is a cylinder, radial heat flow presents a Gaussian distribution, while heat flow peak in the direction of thickness is decaying then increasing exponentially. The predicted weld geometry had good agreement with the actual results. When collapse and hump were considered, simulation error of temperature distribution was only 1.54%. In addition, cooling curves obtained from the thermal simulation were incorporated into the continuous cooling transformation diagram of EH40 to explain the evolution mechanism of microstructure. It was shown that collapse and hump affected the values and distribution trend of residual stress in different thickness, especially in the high gradient stress zone near the weld center. The collapse mainly affects the residual stress distribution on the top surface, while the hump affects that on the bottom surface. Both of them have little influence on the residual stress in the middle thickness area. The cold contraction of weld metal and the stress concentration caused by weld shape during the cooling process are the fundamental reasons that collapse and hump affect the distribution of welding residual stress.

Analysis of laser induced plasma behavior and process stability in high power CO_2 laser welding of homemade ship plate

Design and Analysis of a Novel Ship Pipeline Welding Auxiliary Device

Study on Side Assist Blowing Gas with Different Composition in High Power CO_2 Laser Welding

ICONE19-43939 Phenomenological Evaluation of Laser-Irradiated Welding Processes with a Combined Use of Higher-Accuracy Experiments and Computational Science Methodologies : (5) Numerical Simulation of the Welding Processes with a Multi-Dimensional Multi-Physics Analysis Code SPLICE

Research progress of laser welding under subatmospheric pressure

Progress on laser-plasma arc hybrid welding

Effect of liquid column on process stability and weld formation under ultra-high power fiber laser-arc hybrid welding of thick plates

Research on the dynamic process and defect formation in laser-arc hybrid welding of 12-mm thick AH36 steel

Influencing mechanism of high speed on the droplet transfer and process stability during high-power laser-arc hybrid welding

Prevention and mechanical analysis of porosity formation in pulsed CO2 laser welding of 30CrMnSiA

Effects of heat source configuration on the welding process and joint formation in ultra-high power laser-MAG hybrid welding

Mechanism, Modeling, and Application of Plasma Current in Deep-Penetration Laser Welding

Investigation of Weld Root Defects in High-Power Full-Penetration Laser Welding of High-Strength Steel

Effect of collapse and hump on thermomechanical behavior in high-power laser welding of 16-mm marine steel EH40

Sensing and Control System of Process Quality in Co2 Laser Deep Penetration Welding

Welding Mode Transition and Process Stability in High Power Laser Welding

The Behavior and Its Control of Plasma Produced During Laser Welding

Research on laser welding of vehicle body

Simple Plasma Current Model and Its Application in Laser Beam Welding

Investigation on Porosity Suppression in Deep-Penetration Laser Welding by Using Computational Fluid Dynamics

Understanding the Effect of Oxygen on Weld Pool and Keyhole in Laser Beam Welding