Abstract:(1) Background: the applications of ceramic materials in a friction pair and a moving pair are limited, just because of their poor toughness and unsatisfactory tribological characteristics. In view of this, Mo as a soft metal layer was added into a Si3N4 matrix to improve its toughness and tribological characteristics. (2) Methods: The microstructure and metal/ceramic transition layer were examined using X-ray diffraction, scanning electron microscope, electron dispersive X-ray spectroscopy, and Vickers hardness. Bending strength and fracture toughness were also measured. Tribological characteristics were obtained on the pin-on-disc wear tester. (3) Results: It can be found that the multilayer structure could improve the fracture toughness of laminated composite compared with single-phase Si3N4, but the bending strength was significantly reduced. Through microstructure observation, the transition layer of Si3N4/Mo-laminated composite was revealed as follows: Si3N4→MoSi2→Mo5Si3→Mo3Si→Mo. Moreover, the addition of the Mo interface to silicon nitride ceramic could not significantly improve the tribological properties of Si3N4 ceramic against titanium alloy in seawater, and the friction coefficients and wear rates of the sliding pairs increased with the increase in load. (4) Conclusions: The process failed to simultaneously improve the comprehensive mechanical properties and tribological performance of Si3N4 ceramic by adding Mo as the soft interfacial layer. However, the utilization of metal interfacial layers to enhance the toughness of ceramics was further recognized and has potential significance for the optimization of ceramic formulation.

Study on the Conductive Property of Si3N4-MoSi2 Composite Ceramics

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

The topological analysis of the composite MoSi2-SiC

Experimental and numerical investigation of the effective thermal conductivity of MoSi2–RSiC composites with a three-dimensional interpenetrating network structure

Electrical Resistivity and Microstructure of Pressureless Reactive Sintered MoSi2–SiC Composite

The effect of Si content on the structure and tribological performance of MoS2/Si coatings

The effect of 15 wt% Mo addition on the microstructure and mechanical properties of MoSi2 composite

Influence of Mo Doping on the Microstructure and Dielectric Property of Alumina Ceramic/Metal Composites

Microstructure, Mechanical and Tribological Properties of Si<sub>3</sub>N<sub>4</sub>/Mo-Laminated Composites

Effect of In-Situ Formed MoSi2 on Phase Transformation and Thermal Diffusivity of Spark Plasma Sintered Silicon Nitride

Phase composition and mechanical properties of in-situ synthetic Mo-Si compound composites

The Microstructure and Mechanical Property of Mo(Si, Al)2-SiC Composite Prepared by Infiltrating Melt Aluminum

Microstructure, Mechanical and Tribological Properties of Si3N4/Mo-Laminated Composites

Effect of Silicon Addition on Mechanical Properties of Mullite-Sic Composite Refractories

The study of pressureless-sintered Mo(Si,Al)(2)-SiC composite

Microstructure and mechanical properties of in situ SiC particulates reinforced MoSi2 matrix composite

Preparation and mechanical properties of Fe/Mo–Sialon ceramic composites

Electrically conductive Si3N4 bonded SiC: effect of Fe2O3, MoO3, and SiC particle size

Study Of Electrical Conductivity Of Tic/Si3n4 Ceramic Composites

MoSi2 Inter-Metallic Composites Reinforced and Toughened by CNTs

In-situ Preparation of Nano MoSi 2 SiC Composite by Melt Infiltration of Silicon Method