Abstract:The present paper introduces the stray light and bandpass correction methods for spectrometers. The line spread function of spectrometer is characterized by a He-Ne laser. Assuming that the spectrometer is a wavelength invariable system, the stray light distribution matrix is constructed by the derived line spread functions. The stray light correction matrix is then derived by matrix conversion from the stray light distribution matrix. The measured signals of the spectrometer are finally multiplied by the stray light correction matrix to correct the stray light errors. The bandpass functions of the spectrometer are characterized in three different wavelength ranges, respectively. And then three groups of bandpass correction coefficients are calculated accordingly. The calculation is divided into several steps. Given the measurement results at the target wavelength position and the ones on the neighbor bandwidths, the bandpass correction results are obtained by weight averaging of them. The bandpass correction coefficients are used as the weights. The two correction methods are applied to a multi-channel fast spectrometer to measure LEDs of different color. The results show that the stray light and the bandpass errors can be corrected effectively. The chromaticity coordinates of the LEDs are corrected by (-0.003, 0.007) for the maximum. Furthermore, the method introduced in this paper can reduce the application cost, simplify the calculation under a reasonable precision, and make the application of the correction easier.

Measuring Planck Constant Using Light Emitting Diodes

Stray Light And Bandpass Correction In The Spectral Measurement For Light Emitting Diodes

Accelerated Life Test for High-Power White Led Based on Spectroradiometric Measurement

Measurement of Led Spatial Intensity Distribution Using Imaging

Fast and High-Accuracy Spectral Measurements of LED by Linear CCD Sensor and Software Calibration

Spectrum measurement for LED-based spectrum-tunable source

Novel Measurement System and Analytical Method for White LED Phosphors

An Improvement on the Junction Temperature Measurement of Light-Emitting Diodes by Using the Peak Shift Method Compared with the Forward Voltage Method

Experiment of Planck Constant Measured with Method of Photoelectric Effect

Study on a system for LED's photometric and colorimetric measurement based on a multi-channel spectrometer

Study on a Spectrophotometer System for Measuring LED's Photometric Parameters

Study on the Carrier Lifetime of RGB Mini-Light-Emitting Diodes Based on Phase-Sensitive Detection

Connections of current/voltage characteristics and photoluminescence performances in LEDs

Experimental Study of Measuring LED's Temperatures Via Thermocouple

Measuring Plank constant with an incandescent lamp as the source--The experimental problem of the 36th International Physics Olympiad

Improving Peak-Wavelength Method to Measure Junction Temperature by Dual-Wavelength Leds

A Design for &Lt;italic>in-Situ</italic> Measurement of Optical Degradation of High Power Light-Emitting Diodes under Accelerated Life Test

Accurate Measurement and Influence on Device Reliability of Defect Density of A Light-Emitting Diode

A Design of LED Light Intensity Distribution Measuring Device and Fitting in Matlab

Effect of Deep-Level States on Electroluminescence and I-V Characteristics of White Light-Emitting Diodes

Methodology for Measurement of the Blue Light Hazard of Light-Emitting Diodes with Imaging Luminance Meter