Abstract:Common terminal voltage measurement can be hardly applied to detect quenches in long high temperature superconducting (HTS) conductor on round core (CORC) cable because not only the HTS normal zone propagation velocity (NZPV) is low but also immobilizing a large number of voltage leads is inconvenient. Distributed optical fiber sensing (DOFS) technology is a promising method for quench detection of long superconductors. To sense the thermal changes of CORC cables during quenches more directly and prevent optical fibers from damages by external stress, a fiber-superconducting composite (FSC) CORC cable was fabricated. For this cable, three optical fibers were placed in three grooves of the copper core respectively, then three HTS tapes were spirally wound on the copper core in sequence. Comparing to a traditional CORC cable, obviously, the FSC CORC cable structure has been changed. To promote FSC CORC cable engineering applications, it is necessary to study the fundamental performance of the cable. In this paper, we investigated the electromagnetic, thermal and mechanical properties of the FSC CORC cable by comparing those with a common one. The results demonstrated that, compared to the common one, the magnetic distribution of the FSC CORC cable hardly changed, but the current distribution of the copper core in the FSC CORC cable slightly changed which led to decreases of transport AC loss, in addition, the thermal characteristics of the FSC CORC cable was slightly changed and the bending tolerance ability of the cables reduced within a bending diameter range of 15 cm. What's more, the embedded optical fibers combined with a distributed optical fiber sensing (DOFS) system are successfully used to detect the temperature changes of the cable surface. Finally, to study the quench behaviors of the cable, we built a quench detection platform, which equips with a voltage acquisition system, a thermocouple temperature acquisition system and the DOFS system. By using the platform to detect the quenches of the FSC CORC cable, minimum quench energy (MQE) of the cable and NZPV of the tape and cable at different currents was tested.

Study on properties test procedure for superconducting cables

Study on service test procedure for superconducting transformers

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Study on service test procedure for superconducting fault current limiters

Study on service test procedure for superconducting magnetic energy storage system

Electromagnetic characterization of high-temperature superconducting cables with partial tape faults

Outlines of the Development of High Temperature Superconducting Cables

Fundamental study on performances of fiber-superconducting composite CORC cable: Electromagnetic, thermal, mechanical and quench behaviors

AC Loss Analysis of 35-kV Superconducting Cables Operating at Full Load

Effect of Multilayer Configuration on Ac Losses of Superconducting Power Transmission Cables Consisting of Narrow Coated Conductors

Development of Superconducting Power Technology and Performance Test of Superconducting Power Device

A Novel AC Loss Measurement Technology for High Temperature Superconducting Cable With Large Current Capacity Using a Compensation Coil

Study on Development Characteristics of Cavity Discharge in Composite Insulation of Superconducting Cable

An Experimental Investigation of Critical Current and Current Distribution Behavior of Parallel Placed HTS Tapes

Study on the Current Distribution and Structural Optimization of a High-Temperature Superconducting AC Power Cable

Investigation on the transportation properties of high temperature superconducting wires in low parallel magnetic fields and its significance in cable applications

DEVELOPMENT OF HIGH TEMPERATURE SUPERCONDUCTING CABLE

Comparison of Critical Current of Bi-2212 Cables with Disassembled Strands

An Electrometric Method with Real-time Transport AC Loss Measurement in Superconducting Tapes Based on Compensation Theory

International Round-Robin Test of Critical Current of Superconducting Cable Sample