Abstract:Common terminal voltage measurement can be hardly applied to detect quenches in long high temperature superconducting (HTS) conductor on round core (CORC) cable because not only the HTS normal zone propagation velocity (NZPV) is low but also immobilizing a large number of voltage leads is inconvenient. Distributed optical fiber sensing (DOFS) technology is a promising method for quench detection of long superconductors. To sense the thermal changes of CORC cables during quenches more directly and prevent optical fibers from damages by external stress, a fiber-superconducting composite (FSC) CORC cable was fabricated. For this cable, three optical fibers were placed in three grooves of the copper core respectively, then three HTS tapes were spirally wound on the copper core in sequence. Comparing to a traditional CORC cable, obviously, the FSC CORC cable structure has been changed. To promote FSC CORC cable engineering applications, it is necessary to study the fundamental performance of the cable. In this paper, we investigated the electromagnetic, thermal and mechanical properties of the FSC CORC cable by comparing those with a common one. The results demonstrated that, compared to the common one, the magnetic distribution of the FSC CORC cable hardly changed, but the current distribution of the copper core in the FSC CORC cable slightly changed which led to decreases of transport AC loss, in addition, the thermal characteristics of the FSC CORC cable was slightly changed and the bending tolerance ability of the cables reduced within a bending diameter range of 15 cm. What's more, the embedded optical fibers combined with a distributed optical fiber sensing (DOFS) system are successfully used to detect the temperature changes of the cable surface. Finally, to study the quench behaviors of the cable, we built a quench detection platform, which equips with a voltage acquisition system, a thermocouple temperature acquisition system and the DOFS system. By using the platform to detect the quenches of the FSC CORC cable, minimum quench energy (MQE) of the cable and NZPV of the tape and cable at different currents was tested.

Electromagnetic characterization of high-temperature superconducting cables with partial tape faults

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

An Experimental Investigation of Critical Current and Current Distribution Behavior of Parallel Placed HTS Tapes

Research on Fault Current Endurance Capability of Concentric HTS Cable

Analysis of AC Transport Loss in Conductor on Round Core Cables

Transient Analysis of HVDC HTS Cable in Power Grid Using Discretized Electrical-Thermal Model

Electromagnetic Assessment and AC Losses of Triaxial Cables with Multiple 2G-HTS Layers Per Phase

Numerical Analysis on the Current Distribution and the Loss in HTS Stacked Tapes Considering Termination Resistances

Temperature Analysis of HTS Cables in Superconducting DC Energy Pipeline During Short-circuit Fault

Research on overcurrent stability of HTS cable for energy pipeline

Effect of Multilayer Configuration on Ac Losses of Superconducting Power Transmission Cables Consisting of Narrow Coated Conductors

HTS Cable Design for Aircraft Application Considering Fault Conditions

AC Loss Analysis of 35-kV Superconducting Cables Operating at Full Load

Fundamental study on performances of fiber-superconducting composite CORC cable: Electromagnetic, thermal, mechanical and quench behaviors

Intelligent surrogate model of a high temperature superconducting cable for reliable energy delivery: Short circuit fault performance

Influence of HTS tape arrangement on the transverse compression performance of copper former CORC cables

Typical Defect Simulation of 110kv Cable and Its Partial Discharge Characteristic Test

High Temperature Superconducting Cables and their Performance against Short Circuit Faults: Current Development, Challenges, Solutions, and Future Trends

Investigations on Quench Recovery Characteristics of High-Temperature Superconducting Coated Conductors for Superconducting Fault Current Limiters

Flux-transfer losses in helically wound superconducting power cables

Understanding and minimizing ac losses in CORC cables of YBCO superconducting tapes