Abstract:The current-voltage characteristics of superconductors are commonly determined by means of a standard 4-probe DC measurement technique. In coated conductors, however, one often encounters problems due to weak or no stabilization and in such case, when the risk of burning the tape is high, the 4-probe approach can fail. In other cases such as in HTS cable structures, besides vulnerability and high risk of damage, it may also be difficult to achieve a high critical current level with a power supply that is normally used to characterize single strands. We therefore investigated an alternative method to determine the DC I-V curve, based on measuring the AC transport loss as a function of frequency in overcritical current range. In the AC regime, both the hysteretic loss component and the joule dissipation are present for applied transport currents exceeding the critical current Ic. In this work, AC loss measurements at different frequencies are related to different electric fields in DC and a curve similar to the DC I-V is obtained. From this curve, the power index N and Ic values are estimated. AC regime operation can be more beneficial for two reasons: firstly, because very high currents can be achieved easily by using a transformer; secondly, because the effective joule heat dissipation with overcritical AC currents is much lower than that with DC of the same amplitudes. In the experiment, we used a 4 mm wide YBCO reference tape with 20 {\mu}m of Cu-stabilization. For the comparison with AC transport loss, the sample was measured with the standard 4-probe technique and remained stable even in overload condition. To support our study, numerical simulations, reproducing both transient and stationary operation conditions, were performed. A similar relation between the AC current transport loss and the I-V curves was also observed in the simulations.

An Electrometric Method with Real-time Transport AC Loss Measurement in Superconducting Tapes Based on Compensation Theory

A Loss Measurement Approach of Power Magnetic Components under Practical Power Electronics Conditions

Analysis of Conductor Loss in Interdigital Capacitor Based Measurement of Dielectric Constant of Ferroelectric Thin Film

AC loss modelling in superconducting coils and motors with parallel tapes as conductor

Ac Losses in Hts Tapes and Devices with Transport Current Solved Through the Resistivity-Adaption Algorithm

Computation of Losses in HTS Under the Action of Varying Magnetic Fields and Currents

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

An Investigation on AC Loss Reduction for Permanent-Magnet Superconducting Electrical Machine

Electromagnetic characterization of high-temperature superconducting cables with partial tape faults

AC Loss Measurement of Bi-2223 Conductors

Magnetic flux penetration and AC loss in a composite superconducting wire with ferromagnetic parts

Simulation and Test of Energy Consumption of High-Tc Superconducting Coils in Electromagnetic Levitation System

Effect of combining a DC bias current with an AC transport current on AC losses in a High Temperature Superconductor

Influence of the voltage taps position on the self-field DC and AC transport characterization of HTS superconducting tapes

A DC Differential Method for Core Loss Measurement under Sinusoidal Excitation

AC Loss Analysis of 35-kV Superconducting Cables Operating at Full Load

Iron Loss Separation in High Frequency Using Numerical Techniques

Study on the Influence of Skin Effect on AC Loss of YBCO Tape

Losses in Superconductors under Non-Sinusoidal Currents and Magnetic Fields

Understanding and minimizing ac losses in CORC cables of YBCO superconducting tapes

Measurement of AC loss down to 25 K in a REBCO racetrack coil for electrical aircraft motor