Abstract:The current-voltage characteristics of superconductors are commonly determined by means of a standard 4-probe DC measurement technique. In coated conductors, however, one often encounters problems due to weak or no stabilization and in such case, when the risk of burning the tape is high, the 4-probe approach can fail. In other cases such as in HTS cable structures, besides vulnerability and high risk of damage, it may also be difficult to achieve a high critical current level with a power supply that is normally used to characterize single strands. We therefore investigated an alternative method to determine the DC I-V curve, based on measuring the AC transport loss as a function of frequency in overcritical current range. In the AC regime, both the hysteretic loss component and the joule dissipation are present for applied transport currents exceeding the critical current Ic. In this work, AC loss measurements at different frequencies are related to different electric fields in DC and a curve similar to the DC I-V is obtained. From this curve, the power index N and Ic values are estimated. AC regime operation can be more beneficial for two reasons: firstly, because very high currents can be achieved easily by using a transformer; secondly, because the effective joule heat dissipation with overcritical AC currents is much lower than that with DC of the same amplitudes. In the experiment, we used a 4 mm wide YBCO reference tape with 20 {\mu}m of Cu-stabilization. For the comparison with AC transport loss, the sample was measured with the standard 4-probe technique and remained stable even in overload condition. To support our study, numerical simulations, reproducing both transient and stationary operation conditions, were performed. A similar relation between the AC current transport loss and the I-V curves was also observed in the simulations.

Effect of combining a DC bias current with an AC transport current on AC losses in a High Temperature Superconductor

Study of coupling loss on bi-columnar BSCCO/Ag tapes by a.c. susceptibility measurements

Ac Losses in Hts Tapes and Devices with Transport Current Solved Through the Resistivity-Adaption Algorithm

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

Magnetic flux penetration and AC loss in a composite superconducting wire with ferromagnetic parts

Losses in Superconductors under Non-Sinusoidal Currents and Magnetic Fields

AC Loss Measurement of Bi-2223 Conductors

AC losses in superconducting composite strips in a magnetic field in the form of a standing wave

Frequent JJ decoupling is the main origin of AC losses in the superconducting state

Analysis of AC Transport Loss in Conductor on Round Core Cables

The Influence of Tape Arrangements on the Critical Current of Bi-2223 Superconducting Current Leads

Influence of the voltage taps position on the self-field DC and AC transport characterization of HTS superconducting tapes

Study on the Influence of Skin Effect on AC Loss of YBCO Tape

Computation of Losses in HTS Under the Action of Varying Magnetic Fields and Currents

Experimental Study on AC Loss of 1G and 2G HTS Coils with an Identical Structure, Geometry and Number of Turns

Flux-transfer losses in helically wound superconducting power cables

Enhanced Superconductivity Induced by the Hexagonal-Array-Cooling-Shrinkage Effect

Effect of substrate magnetism on the ac loss of high temperature superconductor tape-wound coils

Theoretical and experimental study of AC loss in HTS single pancake coils

Reduction Of Ac Transport And Magnetization Loss Of A High-T-C Superconducting Tape By Placing Soft Ferromagnetic Materials At The Edges

Calculation of AC losses in stacks and coils made of second generation high temperature superconducting tapes for large scale applications