Abstract:Considering the inherent advantages of the Light Emitting Diode (LED) in the field of illumination, this work designs an intelligent supplementary lighting system using LED as the light source. Combining microcontroller and electronic circuit theory, the circuit is built with the microcontroller PIC16F873 as the core control chip. The system utilizes an external 220 V AC-20 V DC conversion power supply, hence operating on a 20 V DC power source. The system consists of four hardware parts: the onboard power supply uses TI-produced TPS54331 as the control chip to achieve voltage conversion; the external signals (flashing and burst flashing signals) are isolated from the microcontroller through an optocoupler circuit; the PWM pulses output from the microcontroller’s RC1/CCP2 pins drive the corresponding switching tubes to achieve the flashing function; the flashing synchronization signal is output externally after optocoupler isolation, and its synchronous output with the flashing signal is achieved through an optocoupler after LED conduction; the circuit is established using TI-produced differential bus transceiver SN65LBC184D to convert the external 485 differential signal to the level signal required by the microcontroller. In the experiment, after completing the hardware design, connecting the LED panel, and debugging the test program, it is found that the designed lighting system has a good supplementary lighting effect. According to the PWM output waveform, the flashing effect meets the design expectations. The Hadoop big data computing platform is introduced. Simulation testing reveals that under no backlight conditions, the system achieves an illumination intensity of around 20 klx at a distance of about 10 meters. With backlight conditions, the system maintains an illumination intensity of around 1.5 klx at a distance of about 10 meters. Further calculations are performed to analyze the variation in foot traffic within the test area’s illumination over 24 hours. The total illumination intensity during different time intervals is compiled, confirming that the system can autonomously adjust the illumination intensity of the area based on changes in foot traffic.

Design of LED Measurement Instrument Based on Max1647

Research on illumination measurement system by segmented calibration based on MCU

Fast and High-Accuracy Spectral Measurements of LED by Linear CCD Sensor and Software Calibration

Spectrum measurement for LED-based spectrum-tunable source

Stray Light And Bandpass Correction In The Spectral Measurement For Light Emitting Diodes

Intelligent Measuring System for Performance Parameters of Laser Range Finder

Measurement of Led Spatial Intensity Distribution Using Imaging

Design of precision light intensity modulation for light-addressable potentiometric sensor

Design of optical and electrical measurement system for LED

Study on a system for LED's photometric and colorimetric measurement based on a multi-channel spectrometer

Novel Measurement System and Analytical Method for White LED Phosphors

Light-addressable potentiometric sensor based on precise light intensity modulation for eliminating measurement error caused by light source

A research of laboratory instrument for LED property measurement

Design and Implementation of LED Indicating lamp Automatic Measurement Instrument

A Design of LED Light Intensity Distribution Measuring Device and Fitting in Matlab

A novel technique for rapid measurement of LED spatial chromaticity and photometric distribution

Study on a Spectrophotometer System for Measuring LED's Photometric Parameters

Design of Display Measurement System Based on AT89C52 and CPLD

Automatic Monitoring and Controlling LED Energy Saving Lighting System Based on C8051F020 MCU

Discussion about problems in measuring photometric and colorimetric parameters of LED

Intelligent Light Emitting Diode Flashing Supplementary Lighting Control Design and Its Big Data Illumination Analysis