Abstract:As demand grows to replace petroleum-derived materials with more environmentally friendly materials, the use of wood in high-performance applications in the automotive industry has received increasing attention. Understanding the behaviour of wood during forming processes is an essential step towards its successful implementation in the automotive sector. This study accordingly investigates the compressive response and failure behaviour of two hardwood species (beech and birch) at different moisture and temperature levels. The experimental tests were conducted at 20, 60, 100 and 140 °C on samples with various moisture levels, ranging from completely dry to wet conditions. The stress–strain curves were analysed, and the failure modes were examined using visual observations and microscopic analyses. The results demonstrated that, when beech and birch were tested in standard laboratory conditions, the dominant mode of failure was the kink band, where the fibres buckled in an approximately sigmoidal shape. However, when the wet wood was tested at temperatures of 60 °C and above, the stress–strain curves showed long stress plateau region as well as strain hardening. We hypothesise that, at elevated moisture and temperature levels, the cell walls, promoted by the improved flexibility of the polymer network, start to fold, hence, the load stabilises or even slightly decreases. This corresponds to the plateau stage in the stress–strain curves of beech and birch. With further loading, the distance between the folds becomes rather small and compaction of the folds (or densification) apears to occur, corresponding to the observed strain–hardening stage. This hypothsis is supported by the concertina-like folds seen in the scanning electron microscope (SEM) graphs of post-tested specimens. Here, we present and discuss the effect of rays, as well as cell wall/lumen ratio, on the compression behaviour of wood, and the stability of the forming process.

Variations Between Longitudinal CompressiveRatio and PDR of Ash Wood

Delayed Elastic Strain and Set-Recovery Evaluation in High-Pressure Densified Hybrid Poplar Wood – New Assessment Considerations

Plastic and Elastic Strains in Poplar Wood under High-Pressure Densification

Effects of High-Pressure Treatment on Poplar Wood: Density Profile, Mechanical Properties, Strength Potential Index, and Microstructure

High-Pressure Treatment of Chinese Fir Wood: Effect on Density, Mechanical Properties, Humidity-Related Moisture Migration, and Dimensional Stability

Characterization and Prediction of Mechanical and Chemical Properties of Luanta Fir Wood with Vacuum Hydrothermal Treatment

High-strain Rate Compressive Behavior of Douglas Fir and Glubam

The compressive behaviour of beech and birch at different moisture and temperature conditions along the grain

Compressive Mechanical Properties of Larch Wood in Different Grain Orientations

Mechanical Properties and Dimensional Stability of Poplar Wood Modified by Pre-Compression and Post-Vacuum-Thermo Treatments

Multi-scale finite element simulation on large deformation behavior of wood under axial and transverse compression conditions

Chemical modification of poplar wood featuring compressible rebound 3D structure as water treatment absorbents

Swelling restraint of thermally modified ash wood perpendicular to the grain

A novel constitutive model for the porosity related super-large deformation and anisotropic behavior of wood under perpendicular to grain compression

Moisture and short-term time-dependent behavior of Norway spruce clear wood under compression perpendicular to the grain and rolling shear

Experimental Study on Bending Creep Behavior of Modified Fast-Grown Poplar Wood in Uncontrolled Condition

Effect of superheated steam pressure on the physical and mechanical properties of sandwich-densified wood

Understanding the mechanical strength and dynamic structural changes of wood-based products using X-ray computed tomography

Mechanical properties of industrial heat-treated wood

Effect of Compression Combined with Steam Treatment on the Porosity, Chemical Compositon and Cellulose Crystalline Structure of Wood Cell Walls

Temperature and time dependence of orthotropic viscoelastic properties of moist wood determined in tensile mode