Abstract:To distinguish how the natural density of soil affects the seismic response of a soil slope, three large-scale shaking table tests are conducted on slopes of different densities under seismic excitations. The natural density of the homogeneous dense slope (HDS, case #1) is 1.65 g/cm3; that of the heterogeneous graded slope (HGS, case #2) increases from 1.35 g/cm3 to 1.65 g/cm3 with depth; that of the homogeneous loose slope (HLS, case #3) is 1.35 g/cm3. The failure processes, acceleration response laws, spectral characteristics, dynamic strain responses and shear stress-strain behaviours observed during the three tests are compared. The results show that the soil density distribution has a significant effect on the seismic response of a slope. The HGS and HLS fail suddenly under peak ground accelerations (PGAs) of 0.6 g and 0.5 g, respectively. The failure zone in the upper HLS is larger than that in the HGS. The acceleration amplification effect of the HDS is weak, while those of the HGS and HLS gradually increase with the PGA. The position and energy required to produce a nonlinear acceleration amplification factor effect are closely related to the natural density of the slope. The acceleration amplification factors of the HGS and HLS show nonlinear effects at 0.50 times and 0.357 times the slope height, respectively, and the corresponding PGAs are 0.4 g and 0.3 g. With an increasing natural density, the acceleration amplification factor decreases gradually, and more energy is required for the slope to fail under earthquake activity. The acceleration response law is related to the shape and amplitude of the peak in the fast Fourier transform (FFT) spectrum. The dominant frequency differences among the FFT spectra show that the lower the natural density of the slope is, the lower the location of damage in the slope. Combining the results of the peak micro-strain and shear stress-strain behaviour of the three slopes, the shear modulus of the HDS is the highest, and that of the HLS is the lowest.

Effective Soil Density for Propagation of Small Strain Shear Waves in Saturated Soil

Effective Soil Density for Small Strain Shear Wave Propagation

Effective Soil Density for Small-Strain Shear Waves in Saturated Granular Materials

Evaluation of Effective Soil Density in Resonant Column Tests

Effective stress in soils under different saturation conditions

Shear Wave Velocity in Sand Considering the Effects of Frequency Based on Particle Contact Theory

The Pragmatic Wave Equations of Transversely Isotropic Saturated Soils

Physical Derivation of Effective Stress from Balance Law and Experimental Evidence

Influence of Water Saturation on Propagation of Elastic Waves in Transversely Isotropic Nearly Saturated Soil.

Analytical Solution For Biot Flow-Induced Damping In Saturated Soil During Shear Wave Excitations

A consistent derivation of soil stiffness from elastic wave speeds

Bearing Capacity Estimation of Soil under A Constructed Building by Rayleigh Wave Method

On wave transmission in saturated soil system separated by a nonlinear isolated layer

Large-scale shaking table tests on the seismic responses of soil slopes with various natural densities

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Compressional Wave Velocity and Its Physical Nature in Saturated Soils with Extreme Permeability Values

Correlation of Shear Wave Velocity with Liquefaction Resistance Based on Laboratory Tests

Guide for Shear-Wave-Based Liquefaction Potential Evaluation

Resistance of full-flow penetrometers in rate-dependent and strain-softening clay

An Improved Method of Evaluating Liquefaction Potential with the Velocity of Shear-Waves

A binary packing material-based method for estimating small-strain shear modulus of sandy soils