Abstract:The large extensional viscosity of dilute polymer solutions has been shown to dramatically delay the breakup of jets into drops. For low shear viscosity solutions, the jet breakup is initially governed by a balance of inertial and capillary stresses before transitioning to a balance of viscoelastic and capillary stresses at later times. This transition occurs at a critical time when the radius decay dynamics shift from a 2/3 power law to an exponential decay as the increasing deformation rate imposed on the fluid filament results in large molecular deformations and rapid crossover into the elasto-capillary regime. By experimental fits of the elasto-capillary thinning diameter data, a relaxation time of less than 100 μs has been successfully measured. In this paper, we show that, with a better understanding of the transition from the inertia-capillary to the elasto-capillary breakup regime, relaxation times close to 10 μs can be measured with the relaxation time resolution limited only by the frame rate and spatial resolution of the high speed camera. In this paper, the dynamics of drop formation and pinch-off are presented using dripping onto substrate capillary breakup extensional rheometry (CaBER-DoS) for a series of dilute solutions of polyethylene oxide (PEO) in water and in a viscosified water and glycerin mixture. Four different molecular weights between 100 k and 1 M g/mol were studied with varying solution viscosities between 1 and 22 mPa s and at concentrations between 0.004 and 0.5 times the overlap concentration, c*. The dependence of the relaxation time and extensional viscosity on these varying parameters was studied and compared to the predictions of dilute solution theory while simultaneously searching for the lower limit in solution elasticity that can be detected. For PEO in water, this limit was found to be a fluid with a relaxation time of roughly 20 μs. These results confirm that CaBER-DoS can be a powerful technique characterizing the rheology of a notoriously difficult material to quantify, namely, low viscosity inkjet printer inks.

Erosion and breakup of polymer drops under simple shear in high viscosity ratio systems

Parallel Breakup of Polymer Drops under Simple Shear

Effect of Pre-Made Compatibilizer and Reactive Polymers on Polymer Drop Breakup

Sheet formation during drop deformation and breakup in polyethylene/polycarbonate systems sheared between parallel plates

Effect of Premade Compatibilizer and Reactive Polymers on Polystyrene Drop Deformation and Breakup in Simple Shear

Drop breakup dynamics of dilute polymer solutions: Effect of molecular weight, concentration, and viscosity

Quantifying the Spatial-Temporal Evolution of Rim/Ligament in Drop Breakup Via Digital In-Line Holography

Dewetting dynamics of sheared thin polymer films: an experimental study

Dewetting of a thin polymer film under shear

Drag Reduction and Degradation of Binary Polymer Solutions

Breakup Promotion of Deformed EPDM Droplets by the Migration of Nanoparticles During Extrusion

An Experimental Investigation on the Secondary Breakup of Carboxymethyl Cellulose Droplets

Breakup Behaviors of Viscoelastic Polymer Droplets in 3-D Pore Throat Structure Microchannel

Breakup Dynamics of Semi-dilute Polymer Solutions in a Microfluidic Flow-focusing Device

Aerodynamic bag breakup of a polymeric droplet

Breakup Dynamics for High-Viscosity Droplet Formation in A Flow-Focusing Device: Symmetrical and Asymmetrical Ruptures

Deformation and breakup behaviors of a Giesekus viscoelastic droplet in Newtonian shear flow

Transient rheology and morphology in sheared nanolayer polymer films

Shear-induced breakdown and agglomeration in nanoparticles filled polymer: The shift of phase boundary and kinetics

Effects of Shear Stress on the Behavior of Volatile Bubbles in the High‐density Polyethylene Melt

Simulation of drop deformation and breakup in simple shear flow