Abstract:Bubble growth processes are highly complex processes, which are not only dependent on the foaming process parameters (temperature, pressure and blowing agent concentration) but also on the type and structure of the polymer used. Since the elongational viscosity at the bubble wall during bubble growth also depends on these influencing factors, the so-called transient elongational viscosity plays a key role in describing the gas bubble growth behavior in polymer melts. The model-based description of the transient elongational viscosity function is difficult due to its dependence on time, Hencky strain and strain rate. Therefore, representative viscosities or shear viscosity models are usually used in the literature to predict the bubble growth behavior. In this work, the transient equibiaxial elongational viscosity function at the bubble wall during bubble growth is described holistically for the first time. This is achieved by extending the so-called molecular stress function (MSF) model by superposition principles (temperature, pressure and blowing agent concentration) and by using the elongational deformation behavior (Hencky strain and strain rate) at the bubble wall during the initial, and thus viscosity-driven, bubble growth process. Therefore, transient uniaxial elongational viscosity measurements are performed and the non-linear MSF model parameters of the two investigated polymers PS (linear polymer chains) and PLA (long-chain branched polymer chains) are determined. By applying the superposition principles and by changing the strain mode parameter to the equibiaxial case in the MSF model, the transient equibiaxial viscosity master curve is obtained and used to describe the bubble growth process. The results show that the extended MSF model can fully predict the transient equibiaxial elongational viscosity function at the bubble wall during bubble growth processes. The bubble growth behavior over time can then be realistically described using the defined transient equibiaxial elongational viscosity function at the bubble wall. This is not possible, for example, with a representative viscosity and therefore clearly demonstrates the influence and importance of knowing the transient deformation behavior that prevails at the bubble wall during bubble growth processes.

Effects of Shear Stress on the Behavior of Volatile Bubbles in the High‐density Polyethylene Melt

Effects of Temperature on Nucleation and Collapse of Volatile Bubbles in the High Density Polyethylene Melt

Erosion and breakup of polymer drops under simple shear in high viscosity ratio systems

Parallel Breakup of Polymer Drops under Simple Shear

Effect of Superimposed Oscillatory Shear on Crystalline Behavior and Mechanical Properties of PE-LLD

Viscoelastic Effects on the Phase Separation in Thermoplastics-Modified Epoxy Resin

Dewetting dynamics of sheared thin polymer films: an experimental study

Dynamics of Bubble Formation in Highly Viscous Liquid in Co-Flowing Microfluidic Device

The Effects of Dispersed Phase Morphology Induced by Flow on the Bulk Viscosity of HDPE/PA Blends

Synergistic and Competitive Effects of Temperature and Flow on Crystallization of Polyethylene during Film Blowing

Prediction of the Bubble Growth Behavior by Means of the Time-, Temperature-, Pressure- and Blowing Agent Concentration-Dependent Transient Elongational Viscosity Function of Polymers

Molecular dynamics simulation of slit rheometer for predicting shear thinning of short polyethylene chains

Evaluating melt foamability of LLDPE/LDPE blends with high LLDPE content by bubble coalescence mechanism

Time-dependent Viscoelastic Behavior of an LDPE Melt

Universal Scaling Behaviors of Entangled Polymer Melts at High-stress Shear

Numerical simulation of polypropylene foaming process assisted by carbon dioxide: Bubble growth dynamics and stability

Experimental study on the dynamics and mass transfer of CO2 bubbles rising in viscoelastic fluids

Interactions between cavitation bubbles and free surfaces of non-Newtonian polymer solutions

Shock and spallation behavior of ultrahigh molecular weight polyethylene

Experimental observation of a confined bubble moving in shear-thinning fluids

Melt Spinning of Shear Modified Plasticized Polystyrene