Abstract:Fatigue indicator parameters (FIPs) serve as the measurement of the driving force for fatigue crack initiation (FCI). The extreme value distributions of FIPs for fatigue life scatter (i.e., fatigue crack initiated from surface or subsurface) in the high cycle fatigue (HCF) to very high cycle fatigue (VHCF) regime are computed of AA7075-T6. The FIPs are averaged in the volume of sub-band in the scale of sub-grain proposed based on the concept of slip system of AA7075-T6 where sub-bands are extracted from statistical volume elements (SVEs) using open-source called Dream-3D. SVEs are built via the experimental crystalline microstructure. The material response variables required in the computation of FIPs are obtained by embedding crystal plasticity theory to the crystal plasticity finite element model via open-source software PRISMS-Fatigue. To meet statistical requirements, 50 instantiations of SVEs are modeled for both traction-free and fully periodic boundary conditions, respectively, corresponding to the surface and subsurface cases under different strain amplitudes (i.e., 0.362%, 0.312%, 0.289%, and 0.254%). It is found that the FIPs are higher under high stress levels indicating that fatigue crack tends to initiate at high stress levels. In addition, the low driving force can be found in the simulations with fully periodic boundary conditions throughout the SVEs, whereas the higher FIPs under traction-free boundary conditions tend to form close to the free surface under cyclic loading conditions. Furthermore, the highest FIPs have a propensity to scatter along with the depth of SVEs with the traction-free surface under strain amplitude of 0.254%, which means the fatigue life in the VHCF regime has a higher scatter. The interactions between the high symmetry of FCC crystalline structure and free surface combining the loading amplitudes have a compound effect on the FIPs, especially at low stress amplitudes, which also has a greater impact on the ultra-high-cycle fatigue life. To this end, the VHCF and HCF experiments are performed under an ultrasonic fatigue experimental system with a frequency of 20 kHz with different stress levels corresponding to the strain amplitude in the simulations. Besides, the morphology fracture surface of presentative samples was observed via the scanning electron microscope (SEM). The comparison between the simulation and the experimental results indicates that the EVD of FIPs is efficient in preciously predicting the FCI and well explain the fatigue life scatter of the AA7075-T6 in the HCF to VHCF regime.

Fatigue Fracture Behavior of a Single-Slip-oriented Fe-35 Wt.% Cr Alloy Single Crystal Containing Fine-Scale Cr-rich Precipitates

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

High-Cycle Fatigue Fracture Behavior and Stress Prediction of Ni-Based Single-Crystal Superalloy with Film Cooling Hole Drilled Using Femtosecond Laser

Microstructure sensitivity of the low cycle fatigue crack initiation mechanisms for the Al 0.3 CoCrFeNi high entropy alloy: in-situ SEM study and crystal plasticity simulation

High temperature in-situ SEM observation and crystal plasticity simulation on fretting fatigue of Ni-based single crystal superalloys

Fatigue crack propagation within Al-Cu-Mg single crystals based on crystal plasticity and XFEM combined with cohesive zone model

Fatigue cracking behavior and life assessment of TC11 titanium alloy in very high cycle regime at two working temperatures

Effect of microstructure and local stress on small crack initiation and propagation paths in coarse‐grained FeCrAl alloys

Low cycle fatigue behavior of precipitation-strengthened Cu-Cr-Zr contact wires

Fatigue life assessment of nickel-based single crystals considering equivalent initial flaw size model and anisotropy

Investigation of the Fatigue Life Scatter for AA7075-T6 Using Crystal Plasticity Finite Element Method in the High to Very High Cycle Fatigue Regime

Life prediction and damage analysis of creep-fatigue combined with high-low cycle loading by using a crystal plasticity-based approach

Fatigue Fracture Mechanism of a Nickel-Based Single Crystal Superalloy with Partially Recrystallized Grains at 550 C by In Situ SEM Studies

Temperature-dependent fatigue response of a Fe44Mn36Co10Cr10 high entropy alloy: A coupled in-situ electron microscopy study and crystal plasticity simulation

Crack initiation mechanisms of micro-textured Ti60 alloys with different dwell sensitivities subjected to fatigue and dwell fatigue loading

In-situ Observations of the Effects of Orientation and Carbide on Low Cycle Fatigue Crack Propagation in a Single Crystal Superalloy

Crystallographic analysis on small fatigue crack propagation behaviour of a nickel‐based single crystal superalloy

Life Assessment of Anisotropic Low Cycle Fatigue of Nickel-Base Single Crystal Superalloy

In-situ observation of strain evolution and ratchetting of growing fatigue cracks

Fretting Fatigue Experiment and Polycrystal Plasticity Simulation in Ni-based Superalloy at Room Temperature and 650 °C