Abstract:With the rapid development of information technology, high-speed digital optical signal transmission technology has become the core of modern communication networks. However, the increase in transmission rates brings challenges such as noise, distortion, and interference, which affect the accuracy of clock recovery. To address these issues, this study proposes a clock recovery algorithm based on the eye diagram opening area to improve the accuracy and efficiency of high-speed digital optical signal jitter measurement. The proposed method extracts clock information from the signal using the opening area and curvature characteristics of the eye diagram for jitter measurement. Experimental results demonstrate that the clock recovery algorithm based on the eye diagram opening area can stably reconstruct the signal eye diagram and obtain jitter parameters under different optical power conditions. At optical powers of -7.2 dBm, -12.2 dBm, and -17.2 dBm, the Q-factors were 8.8, 7.6, and 4.3, respectively, and the RMS jitter values were 12.2 ps, 13.4 ps, and 21.2 ps, respectively. At optical powers of -2.3 dBm, 0.1 dBm, 2.4 dBm, 4.6 dBm, and 6.0 dBm, the Q-factors were 9.1, 9.3, 9.5, 9.7, and 10.0, respectively, and the average jitter values were 8.9 ps, 8.5 ps, 8.0 ps, 7.5 ps, and 7.0 ps. These results indicate that the proposed algorithm performs excellently under low optical power conditions and maintains high recovery accuracy even when jitter increases at higher optical powers. The clock recovery algorithm based on the eye diagram opening area significantly improves the accuracy and stability of high-speed digital optical signal jitter measurement, enriches the theoretical research of clock recovery algorithms, and shows significant advantages in improving signal transmission quality, reducing bit error rate, and enhancing communication link reliability. The research outcomes provide key technical support for the optimization of modern high-speed optical communication systems.

Weighted Voting Method of Clock and Data Recovery for Plastic Optical Fiber Signal

Evaluation of a Subnanosecond Clock and Data Recovery Technique Via Matlab Simulink and Opti-System Co-Simulation

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

Design and Performance Analysis of a Novel Method for Clock and Data Recovery in 10.3125Gbps Optical Mod-Demodulation Systems

A Novel Clock and Data Recovery Technique Based on Sigma-Delta Phase Quantization

A statistical jitter tolerance estimation applied for clock and data recovery using oversampling

A novel approach for clock recovery without pattern effect from degraded signal

Low timing jitter 40 Gb/s all-optical clock recovery based on an amplified feedback laser diode

A Novel Clock And Data Recovery Scheme Based On Sigma-Delta Quantization

Experimental Demonstration Of An All-Optical Clock And Data Recovery Technology For 10 Gb/S Nrz-Dpsk Signals

A Simple Method for Clock Recovery

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

Research on high-speed digital optical signal jitter measurement technology based on clock recovery algorithm using eye diagram opening area

Clock Data Recovery Based on Delay Chain for Medium Data Rate Transmission

Novel approach to reduce the pattern effect in 10-Gb/s clock recovery

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A Clock and Data Recovery Method Based on Phase Detector Implemented by Delay Chain in FPGA

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

A 10-Gb/S Cmos Clock And Data Recovery Circuit Using A Secondary Delay-Locked Loop

Optoelectrical Clock Recovery with Dispersion Monitoring for High Speed Transmission

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector