Abstract:This paper proposes an opto-electronic co- simulation method to evaluate a fast clock and data recovery (CDR) technique for optically switched data centers. The CDR technique is realized by leveraging a phase updating mechanism and also a global synchronous clock. Briefly, in all-optical networks, by applying a global synchronous clock to both transmitters and receivers, CDR will only need to extract phase delay in the receiver node, and then by compensating the phase delay in the transmitter node, the phase locking-process in RX CDR module can be omitted. This can significantly reduce the CDR locking time. The structure is crucial in supporting server-to-server optical communication but is not sufficiently studied in our perspective. In this paper, we add more analysis to the CDR technique and give circuit-level improvements. The analysis and circuit verifications are conducted by designing a novel opto-electronic co-simulation method, where software Opti-system is employed to carry out optical-related simulations, and MATLAB Simulink is employed to carry out electrical related simulations. We first test the validity of the phase updating mechanism with a specifically designed phase interpolator and a modified bang-bang phase detector. Then we analyze the influence of channel jitters and optical carrier power variations. It’s shown that the CDR technique can tolerate channel deterministic jitter and random jitter of 0.5UI and 0.1UI respectively, and can tolerate a carrier power variation from 0dBm to 2dBm.

Design and Performance Analysis of a Novel Method for Clock and Data Recovery in 10.3125Gbps Optical Mod-Demodulation Systems

Experimental Demonstration Of An All-Optical Clock And Data Recovery Technology For 10 Gb/S Nrz-Dpsk Signals

A Novel Clock and Data Recovery Scheme for 10gbps Source Synchronous Receiver in 65nm CMOS.

Experimental Demonstration of 120-Gb/s Nyquist PAM8-SCFDE for Short-Reach Optical Communication

Evaluation of a Subnanosecond Clock and Data Recovery Technique Via Matlab Simulink and Opti-System Co-Simulation

Experimental Study of PAM-4, CAP-16, and DMT for 100 Gb/s Short Reach Optical Transmission Systems.

Demonstration of Field Trial Experiments to Investigate the Cascadability of a 10 Gb/s Optical 3R Regenerator with All-optical Clock Recovery

Optoelectrical Clock Recovery with Dispersion Monitoring for High Speed Transmission

A Novel 10 Gb/S Tdm-Pon Using Embedded Clocks in Centralized Optical Signals and Conventional Cw Receivers for Instantaneous Burst-Mode Data and Clock Recovery

Transmission of 32-Tb/s Capacity Over 580 km Using RZ-Shaped PDM-8QAM Modulation Format and Cascaded Multimodulus Blind Equalization Algorithm

Simultaneous Clock Recovery for 160 Gbit/S Optical Time-Division Multiplexing Signal Using Phase Modulation

Fast-synchronization and Low-Timing-jitter Self-Clocking Concept for 160 Gbit/s Optical Time-Division Multiplexing Transmissions

Transmission Performance Comparison for 100-Gb/s PAM-4, CAP-16, and DFT-S OFDM with Direct Detection

Design and Analysis of a Nanosecond Burst-Mode CDR Using MATLAB/Simulink and Opti-System Co-Simulation

A novel approach for clock recovery without pattern effect from degraded signal

Comparison of 100G PAM-8, CAP-64 and DFT-S OFDM with a Bandwidth-Limited Direct-Detection Receiver

Weighted Voting Method of Clock and Data Recovery for Plastic Optical Fiber Signal

Multiplication-free and hardware-efficient baud-rate timing error detector for Nyquist and faster than Nyquist optical IM/DD systems

100-Gb/s TWDM-PON Based on 10G Optical Devices.

Modulator-Based High-Speed Optical Signal Processing For Optical Time-Division Multiplexing

100 Gbit/s VSB-PAM-n IM/DD Transmission System Based on 10 GHz DML with Optical Filtering and Joint Nonlinear Equalization