Abstract:It is very easy to form hard and brittle phases (chilled structure and martensite) in the interface zone during the welding and cladding process of nodular cast iron which always decrease the tensile strength of the interface. Shrinkage during the freezing and cooling process of the weld and the clad also bring high residual stress which results in cracks in the interface. However, it is very difficult to eliminate hard and brittle phases in the interface. In this study, a new method was adopted to reduce the residual stress during the laser cladding process of nodular cast iron. That is, cladding alloy with low expansion characteristic was prepared to repair the nodular cast iron, and the shrinkage of the claddings could be reduced, which could reduce the residual stress and cracks. Fe-36Ni (Invar 36) alloy powders which show very low coefficient of expansion and NiCu alloy powders which could restrain the hard phases in the interface were used as the cladding powders to repair the pit of the nodular cast iron by designing composite claddings. The microstructure characteristics were identified by Optical microscope (OM) and Scanning electron microscopy (SEM). Chemical composition was conducted using Energy dispersive microanalysis (EDS). The results showed that no obvious cracks forming in the composite cladding layers and the interface. The average hardness of the cladding layer was about 190 HV and the tensile strength is beyond 460 MPa. The thermal expansion coefficient of the cladding layer is obviously lower than that of the substrate at temperatures below 230 degrees C and above 870 degrees C. The cracks were effectively controlled by using NiCu/Fe-36Ni low-expansion composite alloy during the deep pit repair of the nodular cast iron.

Surface Defects Welding Repair Technique of Hi-Cr Cast Iron Castings

GTAW Repair-welding Technology on the Large-size Turbine Generator Rotor Made of the 25Cr2ni4mov

Contribution to the Fracture Mechanics Characterization of Repair Welding of Thick-Walled Ductile Cast Iron Components

Microstructure and Mechanical Properties of Friction Stir Repaired Al–Cu Casting Alloy

Influence of Tungsten on Microstructure and Properties of As-Cast Hi-Cr Cast Iron

Repair Welding of Defects in 2219 Al Alloy Friction Stir Welded Joints

Effect of Cold Metal Transfer Welding Repair Parameters on the Forming for the Repair of Surface Defects of Cast Magnesium Alloy

Cold-Source Composite Welding Repair of 9Cr2Mo Thick-Walled Parts: Microstructure, Mechanical Properties, and Finite Element Simulation

The property of die-casting dies of wiper repaired by laser welding with filler wire

Solid-State Repair of Casting Defects in ZL210 Aluminum Alloy

Research Status of High Chromium Cast Iron Coating

Crack tendency and mechanical properties of ductile cast iron joint by fiber laser-MIG hybrid welding

Deep Pit Repairing of Nodular Cast Iron by Laser Cladding NiCu/Fe-36Ni Low-Expansion Composite Alloy

Microstructure and Wear Resistance of WC and High Chromium Cast Iron Hardfacing Layers

Application of Laser Cladding Reparations

TIG Repairing on Directionally Solidified Superalloy DZ125

Active-passive Filling Friction Stir Repairing of Casting Defects in ZL210 Aluminum Alloys

The Engine Casing Machining Holes Repairing Based on Vibration Wire Feeding

Study on Surface Longitudinal Crack Formation of Typical Hypoeutectoid Steel Produced on a Caster with Billet and Slab

In-situ Solid State Repairing Method for Failure Flat Clinched Joint of Aluminum Alloy

Surface Remanufacturing of Ductile Cast Iron by Laser Cladding Ni-Cu Alloy Coatings