Abstract:A tailor rolled blank (TRB) is a plate of continuously varying thickness with the advantages of lightweight, high strength, and good surface quality. However, it is required that the roll gap can be adjusted online, and the plate and roll produce large elastic deformation in the TRB manufacturing process. These characteristics make the modeling of the force and deformation parameters more difficult. A new mathematical model of roll separating force in the TRB manufacturing process is established taking into account the feature of deformation in this research. The elastic deformation of the strip and the flattening deformation of the roll are considered in order to improve the prediction accuracy of the results. The roll separating forces of the entrance elastic compression region and the exit elastic recovery region are computed using the generalized Hooke's law. A new velocity field is proposed based on the deformation characteristics of the plastic region and velocity boundary conditions, and the power functionals of the internal deformation, shear, friction, and tension are calculated. The analytical models of force and deformation parameters combined the elastic and plastic deformation regions are obtained through iterative operation, which satisfies the convergence condition of the roll separating force and roll flattening. The roll separating force data obtained by the model in this research are compared with the actual measured values in the laboratory, and the deviation value is small, which proves the computational precision of the present model. Additionally, the variations of the entrance velocity and flow volume per second during the TRB manufacturing process are shown, and the influences of the tension and friction factor on the neutral angle and roll separating force are illustrated.

Study of Gap Between Rolls During Two-Roll Straightening Process

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

Study on FEM Simulation of Cage Roll Forming of ERW Pipes

FEM Simulation and Analysis of Roll-Box Model of Square Steel Tubes

RESEARCH ON THEORETICAL MODEL OF PRESS STRAIGHTENING PROCESS AND ITS EXPERIMENT

Finite Element Analysis of Temper Rolling Process

The Simulation of Roll Forming with Multiple Passes

The numerical simulation analysis of the straightening process of the large H-shaped steel

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

FEM Simulation of Main Deformation During Cage Roll-Forming Process

Calculation method and analysis of residual stress in the strip bending roller straightening process

Numerical Simulation of Elastic Deformation of Roller Based on Thermo-Mechanical Coupling

Analysis and application on model of press straightening process with FEM

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

Mathematical modeling and analysis of the tailor rolled blank manufacturing process

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

Study on Roll Forming Process Simulation and Roll Diameters Optimization

Simulation of Rolling for H Beam by 3-Dimension Elastic-Plastic Finite Element

Prediction of Surface Wrinkle Defect of Welding Wire Steel ER70S-6 in Hot Bar Rolling Process Using Finite Element Method and Experiments

Research on material flow stress models in common use