Abstract:The increased switching frequency and speed of silicon carbide (SiC) MOSFETs lead to higher power density of inverters, but meanwhile resulting in weak electromagnetic interference (EMI). The impedance balance technique is a good way to reduce the common mode (CM) noise by making the voltage across the line impedance stabilization network (LISN) as small as possible. However, a side effect of this technique is the generation of relatively large loop current that circulates in the inverter. It can cause additional losses and cost, which can be a factor that stops the increase of the switching frequency by SiC MOSFET. This article, for the first time, analyzes the relationship between the CM noise and loop current of the three-level active neutral point clamped (ANPC) inverter, and proposes a co-reduction method for both. First, the CM noise and loop current are clarified for the ANPC inverter, and the analytical models for both are established. The conflict between the CM noise and loop current is introduced with a specific case by the existing design method. Then a co-reduction method is proposed and elaborated, which can both suppress the CM noise and the loop current. The extra cost and volume by the proposed method are also analyzed and are negligible. The design guideline is further shown for clarity. Finally, the analysis and proposed method is validated by the experiment.

Study of the Effectiveness of Anti-Phase Technique for Common Mode Noise Suppression

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

Novel boost PFC with low common mode EMI: modeling and design

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Impedance-Balancing-based Modulation Strategy for Common-Mode Noise Elimination of CHB Converter

Design of Transformer Shielding Foil Structure for Minimizing Common-Mode Noise in LLC Resonant Converters

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

Suppressing Methods of Common-Mode Noise in LLC Resonant DC-DC Converters

A novel and simple approach to suppress common-mode EMI in power converters

Transformer Structure of Bifilar Primary Winding with Advanced Common Mode Noise Attenuation Performance for Isolated DC-DC Converters

Mirror-Bridge Phase-Shift Modulation With Low Common-Mode Noise for Single-Phase CHB PFC

Analysis and Reduction of Common-mode Noise in Cellular RDCX Converter

Co-Reduction of Common Mode Noise and Loop Current of Three-Level Active Neutral Point Clamped Inverters

A Cascaded Bridgeless Boost PFC With Low Common-Mode Noise

Low Common Mode Noise Half Bridge LLC DC-DC Converter with Asymmetric Center Tapped Rectifier

Phase Leading Input Current Compensation for Crm Boost Pfc Converter

Phase Shading for Light Load Efficiency Improve in Three-Phase Resonant Converter with Integrated PCB Winding Magnetics

A Novel Single-Stage Five-Level Common-Ground-Boost-Type Active Neutral-Point-Clamped (5L-CGBT-ANPC) Inverter

Circuit-level Parallel Strategies of Three Phase PWM Converters Without Zero Sequence Circulating Current

Magnetic Coupling Common Mode Conducted EMI Analysis and Improvement in a Boost Converter