Abstract:The electromagnetic interference (EMI) filter is essential for industrial products to comply with EMI standards. It can reduce the EMI noise, which may cause harmful effects on other electronic devices or human health. However, the EMI filter typically occupies a large volume, around one-third of the entire power supply volume, leading to a deterioration in power density. Among previous studies, the winding cancellation method is an attractive approach for reducing the volume of EMI filter. It can reduce the common-mode (CM) noise by canceling the CM voltages of the transformer without requiring shielding layers. However, the winding cancellation method is only applicable to specific topologies. Particularly, in topologies with an output inductor, the implementation of winding cancellation method requires additional components such as reset windings or capacitors. Therefore, this article proposes a novel coupled inductor rectifier that enables the winding cancellation method without any additional components. The proposed rectifier ensures that the voltages generated at the primary and secondary nodes of the transformer have the same dv/dt directions. Consequently, the CM voltages of the transformer cancel each other, leading to the significant mitigation of CM noise. Furthermore, the proposed rectifier can be implemented simply by replacing the existing output inductor with a coupled inductor. It does not require additional components and has the same circuit characteristics as conventional converters. Finally, the proposed rectifier can be extended to different converter topologies with an output inductor. As a result, the proposed rectifier can achieve high power density by reducing the volume of EMI filter. To verify the performance of the proposed rectifier, laboratory prototypes of forward and asymmetric half-bridge converters were built and tested. The proposed prototypes reduced CM noise by 9.7 and 15.4 dB, respectively, compared to conventional prototypes through winding cancellation. Consequently, the volume of EMI filter in the proposed prototypes was reduced by 55.7% and 75.9%, respectively.

Low Common Mode Noise Half Bridge LLC DC-DC Converter with Asymmetric Center Tapped Rectifier

Research on High Efficiency Half-bridge LLC Resonant Converter

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

A Control Method for the Problem of Losing the ZVS in CCM Mode LLC Converter Caused by Rectifier Parasitic Capacitance

An LLC -DAB Bidirectional DCX Converter with Wide Load Range ZVS and Reduced Switch Count

Full-Bridge LLC Resonant Converter with Parallel-Series Transformer Connection and Voltage Doubler Rectifier

Design of Transformer Shielding Foil Structure for Minimizing Common-Mode Noise in LLC Resonant Converters

Research on the Method for Optimizing the Efficiency of Half Bridge LLC Resonant Circuit

Suppressing Methods of Common-Mode Noise in LLC Resonant DC-DC Converters

Impedance-Balancing-based Modulation Strategy for Common-Mode Noise Elimination of CHB Converter

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Analysis and Reduction of Common Mode Current of the Transformer in a Full-Bridge LLC Battery Charger

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter

Mirror-Bridge Phase-Shift Modulation With Low Common-Mode Noise for Single-Phase CHB PFC

Analysis and Reduction of Common-mode Noise in Cellular RDCX Converter

Low Common Mode Noise Cellular RDCX with Single Bus Multi-Level Regulator

Common-Mode Noise Mitigation Method for Planar Transformer Based on FB LLC Converter

A novel three-phase seven-level active clamped converter using H-bridge as a level doubling network

Modeling and Analysis of 2/3-Level Dual-Active-Bridge DC-DC Converters with the Five-Level Control Scheme

Complementary Couple-Turns: An Effective Method for Reducing Common-Mode Noise in Full-Bridge LLC Resonant Converter With Split Primary Winding Transformer

Common-Mode Noise Suppression in Isolated DC-DC Converters Based on Coupled Inductor Rectifier