Static test of a simple support pre-stressed concrete hollow slab with two-way tube fillers

Liu Zhaoqing,Qian Jiaru,Zhao Zuozhou,Xu Yan,Zhao Lei

DOI: https://doi.org/10.15951/j.tmgcxb.2010.09.009

2010-01-01

Abstract:To study the mechanical behavior of simply edge-supported cast-in-situ pre-stressed concrete two-way hollow slabs with tube fillers along the shear transfer directions,static test of a 8m×8m slab was performed under uniformly distributed vertical loads.The test results showed that the bending cracks appeared at the bottom of the slab,expanded along the diagonals and eventually formed plastic hinge lines,and the slab failed in bending.The measured crack load was larger than the calculation.Under the standard load,taking into account the influence of creep of concrete,the measured maximum vertical displacement was less than the code limit value.Under the design load,the reinforcement did not yield.As the pre-stressed strands approached the conditional yield strength,the applied load was larger than the load calculated from the plastic theory.In the end of the test,the maximum vertical displacement reached 1/63 of the span of the slab,the applied load was 1.81 times of the design value.The vertical displacement,the strain of reinforcement and the sectional bending stiffness were,respectively,basically centrally symmetric and symmetrical with respect to the center line of the slab in both directions.It is recommended that for simply edge-supported two-way hollow slabs with tube fillers along the shear transfer directions,stirrups are not necessary in the ribs,the slab can be considered as an isotropic two-way slab,its bending strength and ultimate strength can be calculated by using elastic theory and plastic theory,respectively,and its sectional bending stiffness can be calculated by two-way slab theory.