Abstract:The performance of joint connections in composite slabs is crucial for ensuring their bidirectional load-bearing capacity and overall structural integrity. To effectively address the challenge of protruding rebar in precast components, a new structural form of a tightly connected hollow concrete composite slab without protruding rebar on the slab side is proposed. To investigate the mechanical performance and failure modes of this slab-side tight-joint connected hollow concrete composite slab, bending performance tests under monotonic load were conducted on three tightly connected hollow composite slabs and one seamless hollow composite slab. The analysis focused on the failure modes, crack distribution, bending capacity, and bending stiffness of additional steel bars at the joints of the slabs. The results indicate that, under normal operating conditions, the flexural performance development of concrete hollow composite slabs with tightly connected slab sides is generally consistent with that of the non-spliced cast hollow composite slab. Under ultimate conditions, tearing or brittle fracture failure at the joint interface is likely to occur in the composite slabs, leading to a reduction in flexural bearing capacity. With an increase in joints, the bending capacity of the hollow composite slab decreases by 17.1%, Conversely, when joints are positioned away from the most stressed section, the flexural stiffness of the section increases by 13.5%. A comparison of experimental data and theoretical calculations indicates that the additional rebar at the joints effectively contributes to the lateral load transfer in the hollow composite slab, achieving bidirectional load-bearing capacity. This further validates that the design of the single-joint, tight-joint connected hollow concrete composite slab without protruding rebar meets the requirements for bidirectional load-bearing performance.

Experimental Research on A Self-Supported Floor System

EXPERIMENTAL STUDY OF A NEW RIBBED PRESTRESSED CONCRETE LAMINATED SLAB

Experimental studies of the bearing capability of a type of steel-concrete composite slab

Experimental Evaluation of Steel Beam Bolted to Reinforced Concrete Column Connections

Experimental investigation of prefabricated steel-truss waffle slab under flexural loading

Experimental Study on Flexural Behavior of the Composite Bottom Slab of the Stiffened Steel Truss

Experimental Study of RC Prefabricated Shear Walls with Shear Keys Affected by a Slotted Floor Slab

Experimental and Design Parametric Study of a Novel Grouted Square Steel Tube Upper Chord–Concrete Composite Floor

Experimental research on a new type of steel-concrete composite slab

EXPERIMENTAL RESEARCH ON LIGHT LAMINATED FLOOR STRUCTURE FOR MULTI-LAYER STEEL RESIDENCE SYSTEM

Experimental Study on a Prefabricated Lightweight Concrete-Filled Steel Tubular Framework Composite Slab Structure Subjected to Reversed Cyclic Loading

Experimental study on the flexural performance of concrete hollow composite slabs with tightly connected panel sides

Study on Stiffness of Assembled Monolithic Concrete Hollow Floor with Two-Way Ribs

Elastic Experimental Study On Steel-Concrete Composite Floor With Grid Beams

Deflection prediction of assembly integral steel-concrete floor voided with steel mesh boxes

Static test of a simple support pre-stressed concrete hollow slab with two-way tube fillers

EXPERIMENTAL STUDY ON MECHANICAL PROPERTY OF STIFFENING RIBBED HOLLOW PIPE CAST-IN-PLACE REINFORCED CONCRETE GIRDERLESS FLOOR

Experimental study on reinforcing the prestressed concrete hollow slab with CFRP

Bearing Capacity And Deformations When Bending The Multi-Hollow Floor Slab With Stops At The Ends (In Order Of Discussion)

Experiment and plastic analysis on two-way steel-concrete composite beams

EXPERIMENTAL STUDY ON FLOOR SLABS IN PREFABRICATED SHEAR WALL STRUCTURES USING DRY CONNECTIONS