Abstract:Microwave plasma is known for its versatility in providing tailored operating conditions (pressure, working gas composition and residence time of reagents) for specific applications. Microwave plasma sources (MPSs) are vital in modern applications, demanding continuous improvement. This work introduces a coaxial-line-based nozzleless MPS that operates at atmospheric pressure at an unique frequency of 915 MHz. The measured electrodynamic characteristics in nitrogen of the MPS highlighted the need for improved energy efficiency of the device. The main novelty of this work lies in improving an energy efficiency of the presented MPS, which led to an advanced new version of the device. To achieve this, a dual strategy is employed. Firstly, numerical simulations are used to design a construction modifications to the MPS, which should increase the efficiency of transferring microwave energy from the microwave source to the generated plasma. In this step, a standard model for homogeneous plasma and a two-port equivalent method were used. Then, the theoretical results were experimentally validated by manufacturing a new energy improved version of the MPS. In the new MPS the achieved reflected microwave power (losses) was less than 3% of incident microwave power in the tested range of nitrogen flow rate (50-100 Nl/min). Compared to the MPS before improvement, this means a two-fold decreasing the reflected microwave power. To test the new MPS, the electrodynamic characteristics of the new device version and properties of the microwave plasma generated in nitrogen, using optical emission spectroscopy (OES), were investigated. The OES was used to determine the vibrational Tvib and rotational Trot temperatures of nitrogen molecules and molecular ions. In this work, the estimated Tvib and Trot temperatures for nitrogen molecules ranged from 4000 to 5300 K, depending on discharge conditions, while for nitrogen molecular ions, the temperatures changed between 4700 and 6100 K, respectively. Both the Tvib and Trot temperatures decrease linearly along the plasma flame.

A New Atmospheric Pressure Microwave Plasma Source （APMPS）

A Microwave Air Plasma Source under Atmospheric Pressure

Microwave field distribution in a new atmospheric pressure microwave plasma (APMP) system

Development of Open Type Microwave Plasma Source

Generation of Large-volume Plasma Under Low Air-pressure and Study of Its Electrical Characteristics

A Large-Volume and High-Efficient Microwave Plasma Source with Planes Slotted Antenna

A high efficiency low-temperature microwave-driven atmospheric pressure plasma jet

Atmospheric Pressure Microwave Plasma System with Ring Waveguide

A Large-Volume Microwave Plasma Source Based on Parallel Rectangular Waveguides at Low Pressures

Simulation and Design of New Microwae Plasma Source with Slotted Straight Waveguides

Development and Optimization of Step-A Linear Plasma Device for Plasma-Material Interaction Studies

Simulations and experimental results for a microwave plasma system

The generation and characteristic study of large-volume microwave plasma produced with parellel rectangular waveguides

Microwave atmospheric pressure plasma jet generated from substrate integrated waveguide resonator

Continuous batch synthesis with atmospheric-pressure microwave plasmas

A high-performance microwave plasma source employing dielectric wedges

Design of a Flexible Microwave-Induced Room-Temperature Atmospheric-Pressure Microplasma Source

A Large-Volume Open-Air Microwave Plasma Based on Parallel Multislot Rectangular Waveguides

A Microwave Plasma System with Ring Waveguide

Theoretical and Experimental Study of the Overdense Plasma Generation in a Miniaturized Microwave Ion Source

A new 915 MHz coaxial-line-based microwave plasma source