Abstract:The original Johnson-Cook model's poor prediction of W90 alloy stress at high strain rate and high and low temperatures restricts research and utilization of this alloy. This study used a Split Hopkinson Pressure Bar (SHPB) device to conduct dynamic compression tests on W90 alloy over a temperature range of [-90°C,700°C] and analyze its mechanical behavior. We examined the material's different plastic phase characteristics at high and low temperatures and conducted microstructure research on impact test specimens. Then, we analyzed the stress-strain data from SHPB experiments and quasi-static compression tests on the classical Johnson-Cook model. The original Johnson-Cook model was calibrated using the stress-strain data from SHPB and quasi-static compression tests, and the modified Johnson-Cook model was established and verified. The results show that: low temperature significantly strengthens the material's stress, while increasing temperature thermal softening reduces stress; increasing strain rate increases the strain generated by the workpiece, causing faster strain hardening and thermal softening effects, resulting in higher and more stable stress; low temperature makes thicker grain boundaries, increasing plastic stress, and increasing strain rate also increases plastic stress, as well as making the material's grain boundaries thicker. The increase of strain rate makes the grain more dense, which will also show up in the increase of stress on the macroscopic level; the modified Johnson-Cook model in this paper has high agreement with experimental data, with a mean value of MAPE of only 1.85 %,which is 90.20 % lower than the traditional model, and the average value of the RMSE is 85.56 % lower than the traditional model. The modified model significantly outperforms the traditional model in predicting stress and better describes stress changes in W90 at different temperatures.

A modified Johnson–Cook model for tensile behaviors of typical high-strength alloy steel

A combined Johnson–Cook and Zerilli–Armstrong model for hot compressed typical high-strength alloy steel

A modified Johnson–Cook model for tensile flow behaviors of 7050-T7451 aluminum alloy at high strain rates

A Modified Johnson-Cook Model of As-Quenched AA2219 Considering Negative to Positive Strain Rate Sensitivities over a Wide Temperature Range

A Modified Johnson–Cook Model for 7N01 Aluminum Alloy under Dynamic Condition

Study on constitutive relationship of 6061 aluminum alloy based on Johnson-Cook model

A Modified Johnson-Cook Model for 10%cr Steel at Elevated Temperatures and a Wide Range of Strain Rates

A Modified Constitutive Model for Tensile Flow Behaviors of BR1500HS Ultra-High-Strength Steel at Medium and Low Temperature Regions

A modified Johnson–Cook model for 2A12 aluminum alloys

A Comparative Study on Arrhenius and Johnson–Cook Constitutive Models for High-Temperature Deformation of Ti2AlNb-Based Alloys

The Comparation of Arrhenius-Type and Modified Johnson–Cook Constitutive Models at Elevated Temperature for Annealed TA31 Titanium Alloy

Dynamic tests and constitutive model for 7075-T6 aluminum alloy

Two Methods for the Constitutive Modeling of TiB2/7050 Al Composites

Determination of parameters of Johnson-Cook models of Q235 B steel

A new mathematical model for predicting flow stress of typical high-strength alloy steel at elevated high temperature

Research on Johnson–Cook Constitutive Model of γ-TiAl Alloy with Improved Parameters

Analysis of the High Temperature Plastic Deformation Characteristics of 18CrNi4A Steel and Establishment of a Modified Johnson–Cook Constitutive Model

The Dynamic Mechanics Performance And Constitutive Model Of 30crmnsia High Strength Alloy Steel

A modified Johnson-Cook model considering strain softening of A356 alloy

An Enhanced Johnson–Cook Model for Hot Compressed A356 Aluminum Alloy

Mechanical properties and JC constitutive modification of tungsten alloys under high strain rates and high/low temperatures