Abstract:In this research, a high-efficiency design method of the capacitive MEMS accelerometer is proposed. As the MEMS accelerometer has high precision and a compact structure, much research has been carried out, which mainly focused on the structural design and materials selection. To overcome the inconvenience and inaccuracy of the traditional design method, an orthogonal design and the particle swarm optimization (PSO) algorithm are introduced to improve the design efficiency. The whole process includes a finite element method (FEM) simulation, high-efficiency design, and verification. Through the theoretical analysis, the working mechanism of capacitive MEMS accelerometer is clear. Based on the comparison among the sweep calculation results of these parameters in the FEM software, four representative structural parameters are selected for further study, and they are le, nf, lf and wPM, respectively. le and lf are the length of the sensing electrode and fixed electrode on the right. nf is the number of electrode pairs, and wPM is the width of the mass block. Then, in order to reduce computation, an orthogonal design is adopted and finally, 81 experimental groups are produced. Sensitivity SV and mass Ma are defined as evaluation parameters, and structural parameters of experimental groups are imported into the FEM software to obtain the corresponding calculation results. These simulation data are imported into neural networks with the PSO algorithm. For a comprehensively accurate examination, three cases are used to verify our design method, and every case endows the performance parameters with different weights and expected values. The corresponding structural parameters of each case are given out after 24 iterations. Finally, the maximum calculation errors of SV and Ma are 1.2941% and 0.1335%, respectively, proving the feasibility of the high-efficiency design method.

Design optimization of piezoresistance micro-accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Noise Analysis and Parameter Optimization of Digital MEMS Accelerometer System

Comprehensive Optimization of Pid-Type Closed-Loop Mems Accelerometer System

Determination of Thermally Induced Effects and Design Guidelines of Optomechanical Accelerometers

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

Design Optimization of a Dual Function Piezoelectric Actuator

A New Type of MEMS Accelerometer with Up-Tuning Structure

A Theoretical and Empirical Investigation of Design Characteristics in a Pb(Zr,Ti)O3-Based Piezoelectric Accelerometer

Exploring the performance of piezoresistive accelerometers: modelling, validation, and optimization

Analysis and Optimization for Performance of a Multi-finger Micro-accelerometer

Design and Optimization of the Resonator in a Resonant Accelerometer Based on Mode and Frequency Analysis

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

Theoretical and numerical investigation of a new 3-axis SU-8 MEMS piezoresistive accelerometer

Method for Sensitivity Improvement and Optimal Design of A Piezoresistive Pressure Sensor

Multi-parameter optimization of piezoelectric actuators for multi-mode active vibration control of cylindrical shells

Optimal Distribution Of Actuator/Sensor In Piezothermoelectric Intelligent Structure

Design and Simulation for Tri-Axial Piezoresistive Mems Accelerometer

Method for Performance Improvement and Size Shrinkage of a Three-Axis Piezoresistive Accelerometer with Guard-Ring Structure

Recent Development and Perspectives of Optimization Design Methods for Piezoelectric Ultrasonic Transducers

FEA Based Design Optimization of Exciting Sensitivity for Micromachined Beam Ultrasonic Transducer