Experimental investigation on resistance characteristics in micro/mini cylinder group

Zhigang Liu,Chengwu Zhang,Ning Guan
DOI: https://doi.org/10.1016/j.expthermflusci.2010.09.005
IF: 3.2
2011-01-01
Experimental Thermal and Fluid Science
Abstract:Friction factors associated with forced flow of de-ionized water over staggered and in-line micro/mini cylinder group plates with 3.5mm width and 40mm length, which are made of micro/mini cylinders with hydraulic diameter of 0.5mm and the heights of 1.0mm, 0.75mm, 0.5mm and 0.25mm, respectively, have been experimentally investigated over Reynolds number ranging from 25 to 800. The flux and the pressure drop between the inlet and the outlet of micro/mini cylinder group are measured and the experimental results are compared with those of convectional correlations. The investigation shows the value of fRe is approximately the constant in micro/mini cylinder group plates when the flow is purely laminar state. Except test sections with 0.25mm cylinder height, the values of fRe for other test sections increase when Re>100, as the results of the appearance of vortex resistance, the enhancement of stream pulse and the acceleration of stream frequency. For test section with 0.25mm cylinder height, the values of fRe rapidly and oscillatingly increase at Re>150 due to the influence of the scale effect, tip clearance effect and the roughness effect on the cylinder surface and bottom of micro/mini cylinder group plates. The friction factor in a staggered array is much larger than that at in-line array for micro/mini cylinder group plates and the higher the cylinder height is, the lower the friction factor becomes.
What problem does this paper attempt to address?