Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Forced convective heat transfer characteristics in micro/minicylinders group at low Reynolds number

Experimental investigation on heat transfer of micro-cylinders-group at low reynolds number

Influence of Dimension Effect on Convective Beat Transfer in Micro/mini-Cylinders-group at Low Reynolds Number

Detailed Heat Transfer Measurements of Curved Fin Channels

Influence of heat flux on forced convective heat transfer in duct with micro-cylinder-group

Fluid Flow and Heat Transfer Performance in a Micro-Reactor with Non-Uniform Micro-Pin-fin Arrays for Hydrogen Production at Low Reynolds Number

Numerical investigation on heat transfer of liquid flow at low Reynolds number in micro-cylinder-groups

Numerical Investigation Of Laminar Flow And Heat Transfer In Micro-Cylinder-Groups

Flow resistance and heat transfer characteristics in micro-cylinders-group

Heat and mass transfer characteristics in reforming micro-reactor with micro-pin-fin arrays

Influence of tip clearance on heat transfer efficiency in micro-cylinders-group heat sink

Influence of tip clearance on heat transfer efficiency in staggered micro-cylinders-group

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Influence of heating load on heat transfer characteristics in micro-pin-fin arrays

Effect of different heating power on flow and convective heat transfer characteristics of triangle micro pin fins

Study on the efficient heat transfer mechanism of microchannel pin-fin arrays under low pumping power

The Flow Resistance and Heat Transfer Characteristics of Micro Pin-Fins with Different Cross-Sectional Shapes

Convective heat transfer in micro pin fin heat sinks with different cross section shapes under variable heating loads

Effects of Heating Load on Flow Resistance and Convective Heat Transfer in Micro-Pin-Fin Heat Sinks with Different Cross-Section Shapes

Flow and Heat Transfer Performance of a Mini-Channel Radiator with Cylinder Disturbed Flow

Experimental investigation on resistance characteristics in micro/mini cylinder group