Abstract:In the ultra‐high frequency (UHF) technique, the partial discharge inside the power transformer can be localized by the hyperbolic equations. This method is sensitive to the time difference of arrival (TDOA) between the sensors because a small error in the TDOA vector may introduce a considerable localization error. This sensitivity depends on where the UHF sensors are installed on the transformer tank. By properly positioning the UHF sensors on the tank, this sensitivity is reduced. This paper presents a new method to find the best places on the transformer tank for installing the UHF sensors in such a way that the errors in the TDOA vector have the least effect on the localization accuracy. This paper proposes a new method for improving the partial discharge (PD) localization accuracy by detecting the best places of ultra‐high frequency (UHF) sensors on the power transformer tank. In this way, firstly, the critical sites inside the power transformer that can produce PD are determined. Then the sensors' positioning is done in such a way that if the PD happens at each point of these critical sites, the distance between the estimated PD location obtained by solving the time difference of arrival (TDOA) equations and the actual PD location is laid in an acceptable range. For this purpose, the TDOA equations are linearized around the critical PD coordinates as a matrix form A.X = B. The configuration of the sensor positions that minimizes the condition number of the matrix A is the best configuration. To evaluate the effectiveness of the proposed method, several simulations and evaluations are performed on a power transformer in the CST software. The obtained results and comparing them with the previous method and also conventional arbitrary sensors positioning confirm the effectiveness of this method.

Time-delay Estimation Algorithm of Partial Discharge Ultra High Frequency Signals Based on Higher-order Cumulant

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

Research on Time Delay Estimation Method of Partial Discharges Signal with Improved Weighted Function

Location of PD by Searching in Space Using UHF Method

Multi-Source Partial Discharge Fault Location with Comprehensive Arrival Time Difference Extraction Method and Multi-Data Dynamic Weighting Algorithm

Partial discharge location of power cables based on an improved single-terminal method

Comparison of Different Time-Frequency Analysis Methods for Sparse Representation of PD-induced UHF Signal

Adaptive Time Delay Estimation Based on Signal Preprocessing and Fourth-Order Cumulant

Partial Discharge Automatic Locating Algorithm for Cable under Oscillatory Wave Voltage Conditions Based on Traveling Wave Method

Partial Discharge Direction of Arrival Estimation in Air-insulated Substation by UHF Wireless Array and RSSI Maximum Likelihood Estimator

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Extracting Partial Discharge Signals Using AGR

Partial discharge localisation in transformers using UHF technique: non-iterative method

Accurate Identification Partial Discharge of Cable Termination for High-Speed Trains Based on S-Transform and Two-Dimensional Convolutional Network Algorithm

Partial discharge location algorithm based on total least-squares with Matern kernel in cable systems

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Simulation Analysis on the Attenuation Characteristics of Partial Discharge Ultra-high Frequency Signals in GIS

Time-frequency Analysis of Partial Discharge Signal by Gabor Transform

Ultra‐high frequency sensors positioning on the power transformer to mitigate the negative effects on the partial discharge localization accuracy

Time–frequency Analysis of PD-induced UHF Signal in GIS and Feature Extraction Using Invariant Moments

The Frequency Range Selection for Measurement of Partial Discharge in Transformer Oil with UHF Method and Interference Suppression