Abstract:Understanding the hydrodynamics of the bed layer in a fluidized bed is essential for optimizing and improving fluidized bed flotation units. This study proposes a fluidized bed flotation column that incorporates auxiliary particles into the gas–liquid two‐phase system to address the shortcomings of traditional flotation units. Stainless steel particles (glass beads), tap water, and compressed air were used as the solid, liquid, and gas phases, respectively. Key factors affecting the bed hydrodynamics (such as bed fluctuation, minimum fluidization velocity, bed expansion, and porosity) in the fluidized column include gas and liquid flow rates as well as the initial bed height. Experimental results show that selecting appropriate filling particles can effectively enhance the fluidization performance of the bed, while appropriately increasing the gas flow rate can achieve fluidization at lower liquid velocities, thus reducing energy consumption during the flotation mineralization process. Theoretical analysis combined with extensive data reveals that the expansion characteristics of the fluidized bed and the use of high‐density filling particles can effectively mitigate bed layer fluctuations and stabilize the flow field environment. Additionally, based on a wide range of data, this study employs model factor analysis, dimensionless analysis, and multiple linear regression analysis to propose a standard dimensionless parameter model for the fluidized bed flotation column, which can effectively predict bed layer fluctuations and expansion characteristics.

Flotation Rate Modelling of Deinking Process in Flotation Column

Parameters Analysis of Column Flotation Deinking Process

Effect of Flotation Parameters on ONP/OMG Deinking Efficiency

Optimization Of Flotation Parameters In Deinking Of Onp And Omg

Preliminary research on the deinking ability of column flotation

Study on Deinking with Column Flotation System in Laboratory

Study Of The Efficiency Of Flotation Deinking Using A New Type Of Floatation Cell

The Influence of Flow Characteristics on Flotation Deinking Efficiency in a Deinking Cell

Development Of A Laboratory Floatation Cell And Its Deinking Efficiency

Optimization of key link parameters and mechanism of the jet-stirring synergistic column flotation method

OPTIMIZATION OF FLOTATION PARAMETERS IN OLD BOOK PAPER DEINKING

Non-first-order Kinetics Modelling Method for Stibnite Flotation Process

Evaluation of the Main Factors Influencing Floatation Deinking Efficiency

Kinetics Characteristics in the Treatment of Deinking Effluent with High Performance Inner-Loop Bioreactor

Effects of repulping and flotation methods on deinking efficiency of ONP/OMG recycled pulp

Characterization of Particle Fluidization in a New Type of Fluidized Bed Flotation Unit

Flow of Gas-Liquid-solid System and Its Application in Packed Flotation Column

Technical note a study on the mixing characteristics of a packed flotation column

Laboratory and Pilot Test of Flotation-washing Deinking Agents for ONP Recycling

Research on Rigorous Mechanism Modeling for Distillation Column Series under Wide Variation of Feed Condition

Effects of Aeration Device and Bubbles Distribution of Flotation Cell on the Deinking Efficiency