Abstract:In inland waterways, waves generated by passing boats cause the movement of riprap used for bank protection and stabilization. Previous studies have mainly concerned the natural channel erosion problem caused by wind-generated waves and neglected the research and findings on shipping behavior. This work presents a coupling of the computational fluid dynamics model and the discrete element method. The aim is to first study the interactions between ship waves in the confined channel and the movements of the riprap of the banks and shorelines and second to analyze the stability of these armourstones under the actions of various ship velocities and draught depths. These varying conditions exert influence on the ship-induced waves, the crucial point being the drawdown amplitude, and consequently create more intense flow behavior in the near-shore region, which results in instability and destruction of the overall structure of the armor protection layer. The higher ship velocity and the larger draught depth lead to the aggravation of instability processes of the blocs composing the protective layer. There is a critical phenomenon in the influence mechanism of vessel velocity, whereas the variation process induced by draught depth is relatively linear. In addition, the stability of the blocs also depends on their shapes, sizes, and the initial positions within the protective layer. This study could contribute to the high-quality development of inland navigation.

Study on the Local Reinforcement of the Bilge Structure in Ship End Launching

Coupled Computational Fluid Dynamics-Discrete Element Method for Simulating the Interactions Between Ship-Induced Waves and Riprap on Restricted Waterway Banks

Analysis of the Ship Loader's Vibration Mode in the Roll-On Process and the Reinforcement Scheme

A simplified analyzing method for overall longitudinal strength of pontoon during ship launching

The influence of lateral pressure on ultimate strength of ship structure

Analysis of the overall structural strength and optimization recommendations for ultra-large container ships based on the improved equivalent design wave method

Ultimate Strength of Container Ship Bilge Panels Subjected to Axial Compression Combined with Bending and Lateral Pressure

Strength assessment and reinforcements of self-unloading bulk carrier

Ultimate Strength Experimental Research for Longitudinal Box Girders Module Model

On bottom slamming load and strength requirement for Structures of Box Barges

On the Local Structure Strengthening of the Service Ship

Mechanical analysis and interior stiffeners arrangement discussion of a specific ship side collision situation

Bearing Capacity Analysis and Mechanism Study of Shared Caisson under Multidirectional Loading

Local Strength Study on the Mooring Structure of Multi-Point Mooring for FPSO

A Study of Ultimate Strength for Container Ship Bottom Structures under Bi-axial Loads Considering Corrosion Effects

Experimental and numerical investigation on the ultimate strength of a ship hull girder model with deck openings

Research development of buckling and ultimate strength of hull plate and stiffened panel

Research on Ultimate Strength of Hull Structure Based on Cumulative Plastic

Numerical Investigation of Three-Dimensional Hull Girder Ultimate Strength Envelope for an Ultra Large Container Ship

Reliability Assessment on Residual Ultimate Longitudinal Strength Improvement of a Box Girder Ship Subjected to Cabin Inner Explosion

Sensibility Analysis and Further Development for Dead Ship Stability Criteria Based on Local Linearization Method