Abstract:Microscale boiling heat transfer experiments were performed using acetone as the working fluid in ten parallel silicon microchannels with hydraulic diameters of 155.4 mum. An infrared radiator image system is used for the chip temperature measurements, while an optical system combining a microscope and a high-speed camera is used for transient flow pattern identification. By covering the present data range it is found that all microchannels repeat the transient flow patterns in a timescale of milliseconds while the fluid pressures/temperatures are stable. A full cycle can be subdivided into three substages: liquid refilling stage, bubble nucleation, growth and coalescence stage, and transient annular flow stage. Correspondingly four flow patterns are identified. Paired or triplet bubbles are observed to be nucleated and grow up simultaneously in, or very close to, the channel corners at the same cross section. The nucleated bubbles experience several milliseconds of growth until coalescence takes place. Then a single liquid plug is separated into two parts, which are pushed out of the flow field view in less than 1 ms. In the transient annular flow stage, the liquid films that are drawn into the comers of the channel become less and less versus time. Once a partially or fully dried-out state is reached, all the microchannels are refilled with fresh liquid and a new cycle begins. The probabilities of each flow pattern occurring and the liquid refilling follow the statistical principle well. The measured chip temperatures are not uniform across the whole heating area, attributed to the uneven liquid refilling probabilities for different channels and the uneven possibilities that are immersed in the liquid for different heating regions. The chip temperatures display spatial variation behavior in the majority of the heating area, due to the liquid and vapor alternatively passing through the microchannels. To the authors' knowledge, some of the above experimental findings have not been previously reported.

STUDY ON ALTERNATING FLOW PHENOMENA DURING FLOW BOILING IN SILICON MICROCHANNELS

Pressure Drop and Flow Boiling Instabilities in Silicon Microchannel Heat Sinks

Two-phase Flow Oscillation and Distribution in Parallel Channels During R1233zd(E) Subcooled Flow Boiling: A Numerical Study

Theoretical and Experimental Research on Flow Boiling Heat Transfer in Microchannels for IGBT Modules

Two-Phase Flow Instability of Boiling in A Double Microchannel System at High Heating Powers

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

Two-Phase Flow Phenomena for Boiling in Two Parallel Microchannels

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel

Heat Transfer Characteristics and Flow Pattern Visualization for Flow Boiling in a Vertical Narrow Microchannel

Microscale Boiling Heat Transfer in A Micro-Timescale at High Heat Fluxes

Flow Boiling in Vertical Narrow Microchannels of Different Surface Wettability Characteristics

SIMULATION AND MICRO-PIV RESEARCH ON CLASSICAL MICROCHANNEL FLOW

Exclusion of Nonisolated Splenic Vein in Distal Splenorenal Shunt for Prevention of Portal Malcirculation

Flow map and measurement of void fraction and heat transfer coefficient using an image analysis technique for flow boiling of water in a silicon microchannel

High-frequency Alternating Nucleate Boiling of Water Enabled by Microslot Arrays in Microchannels

Visualization of Flow Patterns and Bubble Behavior During Flow Boiling in Open Microchannels

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Experimental Study and Mechanism Analysis of the Flow Boiling and Heat Transfer Characteristics in Microchannels with Different Surface Wettability

Investigation on visualization and heat transfer performance study of the mini-channel flow boiling

Effect of Running Parameters on Flow Boiling Instabilities in Microchannels