Abstract:The paper presents a technique to obtain an electrically-tunable matching between the series and parallel resonant frequencies of a piezoelectric MEMS acoustic transducer to increase the effectiveness of acoustic emission/detection in voltage-mode driving and sensing. The piezoelectric MEMS transducer has been fabricated using the PiezoMUMPs technology, and it operates in a plate flexural mode exploiting a 6 mm × 6 mm doped silicon diaphragm with an aluminum nitride (AlN) piezoelectric layer deposited on top. The piezoelectric layer can be actuated by means of electrodes placed at the edges of the diaphragm above the AlN film. By applying an adjustable bias voltage Vb between two properly-connected electrodes and the doped silicon, the d31 mode in the AlN film has been exploited to electrically induce a planar static compressive or tensile stress in the diaphragm, depending on the sign of Vb, thus shifting its resonant frequency. The working principle has been first validated through an eigenfrequency analysis with an electrically induced prestress by means of 3D finite element modelling in COMSOL Multiphysics®. The first flexural mode of the unstressed diaphragm results at around 5.1 kHz. Then, the piezoelectric MEMS transducer has been experimentally tested in both receiver and transmitter modes. Experimental results have shown that the resonance can be electrically tuned in the range Vb = ±8 V with estimated tuning sensitivities of 8.7 ± 0.5 Hz/V and 7.8 ± 0.9 Hz/V in transmitter and receiver modes, respectively. A matching of the series and parallel resonant frequencies has been experimentally demonstrated in voltage-mode driving and sensing by applying Vb = 0 in transmission and Vb = −1.9 V in receiving, respectively, thereby obtaining the optimal acoustic emission and detection effectiveness at the same operating frequency.

Measurements of Ferroelectric MEMS Microphones

Miniature Ferroelectret Microphone Design and Performance Evaluation Using Laser Excitation

A New Measurement Microphone Based on Mems Technology

Acoustic Transmission Measurements for Extracting the Mechanical Properties of Complex 3D MEMS Transducers

Implementation of piezoelectric mems microphone for sensitivity and sensing range enhancement

Study of a highly sensitive miniature condenser microphone based on MEMS technology

Piezoelectric Micromachined Microphone with High Acoustic Overload Point and with Electrically Controlled Sensitivity

An electrometric method to measure the mechanical parameters of MEMS devices

A Novel Piezoresitive Microphone MEMS Sensor For Aerospace Applications

Measurement of mechanical properties for MEMS materials

The Recent Progress of MEMS/NEMS Resonators

Progress of MEMS acoustic emission sensor: a review

A highly sensitive fiber-optic microphone based on corrugated MEMS diaphragm with sub-µm thickness

Magnetoelectric Transducer Employing Piezoelectric Ceramic/Ferromagnetic Alloy/High-Permeability FeCuNbSiB Composite

The design and test of MEMS piezoresistive ultrasonic sensor arrays

Piezoelectric MEMS Acoustic Transducer with Electrically-Tunable Resonant Frequency

A Miniature Fiber-Optic Microphone Based on an Annular Corrugated MEMS Diaphragm

Design Of A New Ferroelectrics-Silicon Integrated Microphone And Microspeaker

A novel ferroelectric based microphone

Study on Ferroelectrics-Silicon Integrated Microphone and Microspeaker

A measuring method for the resonant frequency of flexural horn-type transducer using non-contacting piezoelectric sensor