Abstract:This paper studies the phase separation in poly(ether imide) (PEI) modified epoxy resin using imidazole (C11Z-CNS) as epoxy hardener to control its morphology. The sponge-like phase structures were founded at higher PEI concentration (10–25phr), while homogeneous structures are formed at low PEI concentration (5phr). The effects of PEI concentration on curing kinetics and phase structures were studied by differential scanning calorimeters (DSC) and scanning electron microscopy (SEM). It is shown that although the addition of PEI does not change the curing mechanism, the separated morphology becomes finer at high PEI concentration. The curing rate and conversion decrease with the increase of the content of PEI. The chain growth polymerization of these systems caused an early gelation (conversion <10%) and early freezing of morphologies. The evolution of phase separation in the early stage was monitored by synchrotron radiation small angle X-ray scattering (SR-SAXS) and transmission electronic microscopy (TEM). It is suggested that the formation of sponge-like phase structure could be attributed to the strong viscoelastic effects in the early stage of phase separation.

Phase Structure Control of Epoxy/polysulfone Blends — Effects of Molecular Weight of Epoxy Resins

Rheological Study of Epoxy Systems Blended with Poly(ether sulfone) of Different Molecular Weights

Polymerization-induced phase separation in polyethersulfone modified epoxy resin systems: effect of curing reaction mechanism

Rheological Behaviors and Structural Transitions in A Polyethersulfone-Modified Epoxy System During Phase Separation

Viscoelastic Effects on the Phase Separation in Thermoplastics-Modified Epoxy Resin

PHASE MORPHOLOGY CONTROL OF POLYSULFONE-MODIFIED EPOXY RESIN

Study on the Polyethersulfone/bismaleimide Blends: Morphology and Rheology During Isothermal Curing

Polymerization Induced Phase Separation in Poly(ether Imide)-Modified Epoxy Resin Cured with Imidazole

Studies on Phase Morphology Control of Epoxy/PSF Blends

Effect Of Polyethersulfone On The Mechanical And Rheological Properties Of Polyetherimide-Modified Epoxy Systems

Polymerization-induced viscoelastic phase separation in polyethersulfone-modified epoxy systems.

Thermal properties of an epoxy cresol-formaldehyde novolac/diaminodiphenyl sulfone system modified by bismaleimide containing tetramethylbiphenyl and aromatic ether structures

Synthesis and Curing of a Novel Combined Liquid Crystalline Epoxy

Studies on the Phase Separation of Poly(Ether Imide)‐Modified Cyanate Ester Resin

Viscoelastic Effects on the Phase Separation in Thermoplastics Modified Cyanate Ester Resin

Studies on the Phase Separation of a Polyetherimide-Modified Epoxy Resin, 4. Kinetic Effect on the Phase Separation Mechanism of a Blend at Different Cure Rates

Preparation, Curing Properties, and Phase Morphology of Epoxy-Novolac Resin/multiepoxy-Terminated Low-Molecular-weight Poly(phenylene Oxide) Blend

Studies on the phase separation of polyetherimide-modified epoxy resin, 1. Effect of curing rate on the phase structure

Studies on the Phase Separation of Polyetherimide‐modified Epoxy Resin, 2. Effect of Molecular Weight of PEI on the Structure Formation

Studies on the Phase Separation of Polyetherimide-Modified Epoxy Resin, 3. Morphology Development of the Blend During Curing

Studies on the phase separation of polyetherimide-modified epoxy resin, 3 - Part 1 - Morphology development of the blend during curing