Abstract:Methanol as a hydrogen carrier can be reformed with steam over Cu/ZnO/Al2O3 catalysts. In this paper a comprehensive pseudo-homogenous model of a multi-tubular packed-bed reformer has been developed to investigate the impact of operating conditions and geometric parameters on its performance. A kinetic Langmuir-Hinshelwood model of the methanol steam reforming process was proposed. In addition to the kinetic model, the pressure drop and the mass and heat transfer phenomena along the reactor were taken into account. This model was verified by a dynamic model in the platform of ASPEN. The diffusion effect inside catalyst particles was also estimated and accounted for by the effectiveness factor. The simulation results showed axial temperature profiles in both tube and shell side with different operating conditions. Moreover, the lower flow rate of liquid fuel and higher inlet temperature of thermal air led to a lower concentration of residual methanol, but also a higher concentration of generated CO from the reformer exit. The choices of operating conditions were limited to ensure a tolerable concentration of methanol and CO in H2-rich gas for feeding into a high temperature polymer electrolyte membrane fuel cell (HT-PEMFC) stack. With fixed catalyst load, the increase of tube number and decrease of tube diameter improved the methanol conversion, but also increased the CO concentration in reformed gas. In addition, increasing the number of baffle plates in the shell side increased the methanol conversion and the CO concentration.

Simulating a Multiphase Reactor with Continuous Phase Transition

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Novel Phase Inversion Model for Gas–solid Turbulent Fluidized Beds

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

An Innovative Reaction Heat Offset Operation for a Multiphase Fixed Bed Reactor Dealing with Volatile Compounds

Methanol to Propylene Process in a Moving Bed Reactor with Byproducts Recycling: Kinetic Study and Reactor Simulation

Intensification Of Phase Transition On Multiphase Reactions

Simulation and Analysis of Fixed-Bed Reactor for Hydrochlorination of Acetylene

Influence of Hydrodynamic Parameters on Performance of a Multiphase Fixed-Bed Reactor under Phase Transition

REACTOR MODELING OF AN INNOVATIVE LIQUID-SOLID CIRCULATING MOVING BED FOR THE SYNTHESIS OF LINEAR ALKYL BENZENES

A Computationally Efficient Multi-Scale Simulation of a Multi-Stage Fixed-Bed Reactor for Methanol to Propylene Reactions

Modeling of a Pilot-Scale Trickle Bed Reactor for the Catalytic Oxidation of Phenol

Modeling and Simulation of a Three Phase Fixed Bed Catalytic Reactor for the Hydrogenation of 2-ethyl-hexenal

Simulation and Analysis of a Tubular Fixed‐Bed Fischer‐Tropsch Synthesis Reactor with Co‐Based Catalyst

Simulation of an Industrial Trickle Bed Hydrogenation Reactor in the Pulsing Flow Regime

Regulation of catalytic reaction via vapor-phase condensation. 2. Operational realization in a two-stage reactor

The Simulation of an Industrial Fixed Bed Reactor for Methanol Dehydration to Dimethyl Ether

Mathematic Simulation of a Tube-Shell Type Fixed-Bed Reactor for Fischer-Tropsch Synthesis

Modeling and Design of a Multi-Tubular Packed-Bed Reactor for Methanol Steam Reforming over a Cu/ZnO/Al2O3 Catalyst

Modelling and Simulation on Compressible Multi-Component Gas-Liquid Flows with Chemical Reaction and Phase Transition Effects