Abstract:Steady-state tracer gas measurements were carried out to study the gas mixing behaviors in a spout-fluid bed with a cross section of 0.3 m x 0.03 m and height of 2 m. Two different tracer gases were simultaneously injected, one was injected into the spouting gas flow and the other was injected into the fluidizing gas flow. Radial tracer gas concentrations at various bed elevations under different flow patterns were measured. The mechanism of gas mixing was discussed based on the racer gas concentrations and the flow patterns recorded by a high-resolution digital CCD camera. It was found that gas mixing in spout-fluid beds was due to both convection and dispersion. A three-region mixing model was developed to describe the gas mixing in the spout-fluid bed. The spout jet region and the boundary region were modeled with a mass transfer model; the annular region was modeled with a dispersion model. Effects of spouting gas and fluidizing gas flow rate on the gas exchange between the spout jet and the annular dense region, and the gas dispersion in the annular dense region were examined with flow patterns. The results showed that increase in spouting gas velocity and fluidizing gas flow rate could both promote the gas mixing in spout-fluid beds. The gas-solid flow pattern transited from internal jet to spouting to spout-fluidizing, and the gases were better mixed. But the gases became poorly mixed when the flow pattern transited from stable flow to instable flow.

Novel Method to Study the Particle Circulation in a Flat-Bottom Spout-Fluid Bed

New Method for the Investigation of Particle Mixing Dynamic in a Spout-Fluid Bed

Hydrodynamics and Heat Transfer in a Fluidized Bed with Liquid Spray: Particle Color-Change Based Measurement and Modelling

Investigating the Particle Dispersion in a Spout-Fluid Bed Using Particle Trajectory

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

Dispersion Trajectory and Dynamics of Particles Injected from the Sidewall in the Gas–Solid Fluidized Bed

Distribution and Movement of Fine Particles Injected in a Gas–solid Fluidized Bed with Hydrocarbon Liquid Spray

Experimental Investigation on Particle Mixing in Spout-fluid Bed

Experiment on Particle Mixing in Flat-Bottom Spout–fluid Bed

Experimental Investigation on the Translational and Rotational Motion of Biomass Particle in a Spout-Fluid Bed

Experimental and Model Investigations on Gas Mixing Behaviors of Spout-fluid Beds

Experimental investigation of particle mixing behavior in a large spout–fluid bed

Investigating particle phase velocity in a 3D spouted bed by a novel fiber high speed photography method

Experiment study on gas mixture in two-direction spout-fluidized bed

Experimental Investigations on the Effect of the Tracer Location on Mixing in A Spout-Fluid Bed

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Experimental Study of Gas Mixing in a Spout‐fluid Bed

Measurement of Particle Velocity in Spouted Bed Based on the Combination of Fiberscope and High-Speed Photography

On-line Monitoring of Flow Process in a Spout-Fluid Bed by Combining Electrical Tomography and High-Speed CCD Camera

DEM simulation of particle mixing in flat-bottom spout-fluid bed

THERMAL TRACER METHOD FOR MEASURING PARTICLE CIRCULATING VELOCITY IN BUBBLE CIRCULATING FLUIDIZED BEDS