Abstract:Solid concentration and particle velocity distributions in the transition section of a ϕ 200mm turbulent fluidized bed (TFB) and a ϕ 200mm annulus turbulent fluidized bed (A-TFB) with a ϕ 50mm central standpipe were measured using a PV6D optical probe. It is concluded that in turbulent regime, the axial distribution of solid concentration in A-TFB was similar to that in TFB, but the former had a shorter transition section. The axial solid concentration distribution, probability density, and power spectral distributions revealed that the standpipe hindered the turbulence of gas–solid two-phase flow at a low superficial gas velocity. Consequently, the bottom flow of A-TFB approached the bubbling fluidization pattern. By contrast, the standpipe facilitated the turbulence at a high superficial gas velocity, thus making the bottom flow of A-TFB approach the fast fluidization pattern. Both the particle velocity and solid concentration distribution presented a unimodal distribution in A-TFB and TFB. However, the standpipe at a high gas velocity and in the transition or dilute phase section significantly affected the radial distribution of flow parameters, presenting a bimodal distribution with particle concentration higher near the internal and external walls and in downward flow. Conversely, particle concentration in the middle annulus area was lower, and particles flowed upward. This result indicated that the standpipe destroyed the core-annular structure of TFB in the transition and dilute phase sections at a high gas velocity and also improved the particle distribution of TFB. In conclusion, the standpipe improved the fluidization quality and flow homogeneity at high gas velocity and in the transition or dilute phase section, but caused opposite phenomena at low gas velocity and in the dense-phase section.

Experiment study on gas mixture in two-direction spout-fluidized bed

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

Dispersion Trajectory and Dynamics of Particles Injected from the Sidewall in the Gas–Solid Fluidized Bed

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Distribution and Movement of Fine Particles Injected in a Gas–solid Fluidized Bed with Hydrocarbon Liquid Spray

A CFD-DEM study of a two-joint spouting flow pattern in a multiple rectangular spout fluidized bed

Numerical Investigation of the Gas‐Solid Flow Characteristics in a Three‐Dimensional Spouted Bed with a Draft Tube

Three-Dimensional Modeling of Gas–Solid Motion in a Slot-Rectangular Spouted Bed with the Parallel Framework of the Computational Fluid Dynamics–Discrete Element Method Coupling Approach

An XCT study on three-dimensional characteristics of a spout-fluid bed

Gas Mixing In The Cocurrent Downflow Circulating Fluidized-Bed

Influences of operating parameters on the hydrodynamics of a 3-D spout–fluid bed based on DEM modeling approach

Effect of Operating Parameters on Gas‐Solid Hydrodynamics and Heat Transfer in a Spouted Bed

Numerical Investigation of the Time-Related Properties of Solid Phase in a 3-D Spout-Fluid Bed