Abstract:The influences of operating parameters on the gas-solid hydrodynamics of a 3-D spout-fluid bed operated in the flow regime of Jet-In-Fluidization are numerically investigated at the particle-scale level. The gas motion and solid motion are solved under the frameworks of computational fluid dynamics and discrete element method, respectively. The dynamical property of solid phase obtained numerically is compared with the experimental data in literature. Then, the influences of the spouting velocity, the background velocity and the particle diameter on the bed hydrodynamics are discussed. The results show that vigorously lateral motion of solid phase exists in the spout-annulus interface and the vertical transportation intensity is larger than the lateral one. Increasing the spouting velocity enlarges the solid velocity but decreases its concentration in the spout and enhances the solid circulating flux of the system. Meanwhile, the enlargement of background velocity gives rise to an obvious change of voidage in the annulus. However, enlarging the particle diameter lowers the solid motion in three regions of the bed. Spout and annulus interact with each other through the spout-annulus interface. The spout boundary diverges initially, and then keeps nearly constant, finally diverges again until the bed surface. Moreover, the shape of the spouting boundary is strongly influenced by the inlet geometry. Along the bed height, this influence diminishes initially but is enhanced in the vicinity of bed surface. The enlargement of spouting velocity or background velocity leads to the expansion of the spout boundary along the bed height. In contrast, the increase of particle diameter reduces the spout boundary. (C) 2014 Elsevier B.V. All rights reserved.

Experimental Investigation on Particle Mixing in Spout-fluid Bed

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Dispersion Trajectory and Dynamics of Particles Injected from the Sidewall in the Gas–Solid Fluidized Bed

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Hydrodynamics and Heat Transfer in a Fluidized Bed with Liquid Spray: Particle Color-Change Based Measurement and Modelling

Numerical Study of Particle Injection into a Gas-Solid Fluidized Bed

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

Research on Mixing Character of Fluidized Bed Particles with Image Processing Technique

Numerical Investigation of the Time-Related Properties of Solid Phase in a 3-D Spout-Fluid Bed

A CFD-DEM study of a two-joint spouting flow pattern in a multiple rectangular spout fluidized bed

Particle-Scale Simulation of Solid Mixing Characteristics of Binary Particles in a Bubbling Fluidized Bed

Investigation of fluidization behavior of high density particle in spouted bed using CFD–DEM coupling method

An XCT study on three-dimensional characteristics of a spout-fluid bed

Influences of operating parameters on the hydrodynamics of a 3-D spout–fluid bed based on DEM modeling approach

Research on particle mixing in a fluidized bed

Particle‐scale Investigation of the Solid Dispersion and Residence Properties in a 3‐D Spout‐fluid Bed

Computational Fluid Dynamics-Discrete Element Method Investigation of Solid Mixing Characteristics in an Internally Circulating Fluidized Bed