Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Research Status on Closed-loop Control Technique of Laser Forming

Research of Closed-Loop Control of Deposition Height in Laser Metal Deposition

Process and Development of Laser Forming

Research on Precision Control of Sheet Metal Forming by Laser Shock Waves with Semi-Die

Controlling Edge Effects in Laser Bending

Research on the mechanisms of laser forming for the metal plate

The Characteristic and Application of Laser Forming Technology

Research on the Forming Process of Three-Dimensional Metal Parts Fabricated by Laser Direct Metal Forming

Theoretical and Experimental Study on Laser Compound Forming of Plate

Performance Analysis of Closed-Loop Control System Based on Incremental Air-Bending Forming of Sheet Metal

Study on mechanical properties after laser forming

Research on the Mechanisms of Laser Forming for the Micro-Structural Element

Sheet Laser Forming & Research Progress

The Study for Stability of Closed-Loop Control System Based on Multiple-Step Incremental Air-Bending Forming of Sheet Metal

Analysis and Control of Edge Effects in Laser Bending

NUMERICAL INVESTIGATION OF STRAIGHT-LINE LASER FORMING UNDER THE TEMPERATURE GRADIENT MECHANISM

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

The Forming Control Method of Multi-Track Laser Cladding on Curved Surface

Recent Advances in the Laser Forming Process: A Review

Experimental and numerical investigation on laser beam forming of steel sheets

A Study on Bending Direction of Sheet Metal in Laser Forming