Abstract:A series of crystalline porous materials MnCo2O4.5 catalysts were successfully synthesized by a one-step rapid microwave-assisted hydrothermal method (WH) with different microwave efficiency and duration time, which brings better catalytic activity compared with the catalyst MnCo2O4 synthesized by conventional hydrothermal method (CH). The microwave effect could attribute larger specific surface area and exposure more active sites by the Hot Spot effect during the synthesis process. The good activity of porous metal oxides MnCo2O4.5 also comes from the large total pore volume, and abundant oxygen vacancies, according to the characterization results. The difference in toluene catalytic oxidation activity between the samples was investigated using the removal rate and the mineralization rate as assessment criteria. The results shows that the temperature required for complete removal of toluene is as follows: MnCo2O4.5: 200 ℃; MnCo2O4: 250 ℃. The temperature of the total mineralization of toluene is as follows: MnCo2O4.5: 250 ℃; MnCo2O4: 275 ℃. Besides, the best synthesis condition of the catalyst is 250 W (microwave power) and 20 min (microwave time). Therefore, the microwave-assisted method has successfully synthesized crystalline porous materials and achieved excellent catalytic oxidation performance of toluene, and the unique surface characteristics of the catalyst facilitate the catalytic oxidation reaction under the Marse-van Krevelen mechanism.

Rapid Synthesis of La0.7Sr0.3MnO3+λ Catalysts by Microwave Irradiation Process

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

A novel route of synthesizing La1-xSrxCoO3 by microwave irradiation

Synthesis of La_(0.8)Sr_(0.2)CoO_3 by Microwave Irradiation

Fast Optimization of Limgmnox/La2o3 Catalysts for the Oxidative Coupling of Methane

Rapid Synthesis of Rod-Like Pyrolucite MnO 2 by Microwave-Assisted Hydrothermal Method

One-Step Synthesis of Nanocrytalline Perovskite LaMnO3 Powders Via Microwave-Induced Solution Combustion Route

Facile One-Step Flame Synthesis of La1−xSrxMnO3 Nanoparticles for CO Catalytic Oxidation

Enhancement of the redox reactions of the La0.8Sr0.2MnO3 catalyst by surface acid etching: A simple synthesis strategy to high-performance catalysts for methane combustion

Selective Catalytic Reduction ofNOx by Methane over La(1-x)SrxMnO3 Perovskites

Effect of Different Reaction Conditions on Catalytic Activity of La(Mn, Fe)O3+lambda Catalyst for Methane Combustion

La 0.8 Sr 0.2 MnO 3 -Based Perovskite Nanoparticles with the A-Site Deficiency as High Performance Bifunctional Oxygen Catalyst in Alkaline Solution.

Effect of Complexing Species in a Sol–gel Synthesis on the Physicochemical Properties of La0.7Sr0.3Mn0.7Cu0.3O3+λ Catalyst

Rapid One-Step Synthesis of Carbon-Supported Platinum-Copper Nanoparticles with Enhanced Electrocatalytic Activity Via Microwave-Assisted Heating.

Perovskite Hollow Nanospheres for the Catalytic Wet Air Oxidation of Lignin

Surface Speciation in Microwave-Assisted CO Oxidation over Perovskites─The Role of Water and Activation Pretreatment

Promotion of rapid microwave-assisted synthesized porous manganese-cobalt catalyst on low-temperature toluene oxidation

Catalytic performance of rare earth nanometer materials LaMnO3+lambda

Surface characterization and catalytic performance of La0.7 Sr0.3MnO3+λ coating deposited by plasma spraying

Screening Ba0.9A0.1MnO3 and Ba0.9A0.1Mn0.7Cu0.3O3 (A = Mg, Ca, Sr, Ce, La) Sol-Gel Synthesised Perovskites as GPF Catalysts

Postsynthesis Oxygen Nonstoichiometric Regulation: A New Strategy for Performance Enhancement of Perovskites in Advanced Oxidation