Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Design of a Cruciform Biaxial Tensile Specimen for Limit Strain Analysis by FEM

Design of a biaxial tensile testing device and cruciform specimens for large plastic deformation in the central zone

Shape Optimization of a Composite Cruciform Specimen under Biaxial Loading Condition

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Cruciform specimens biaxial extension performance relationship to constitutive identification

A Tensile Characterization Study of Metal Sheet in Large-Strain

An experimental investigation of large-strain tensile behavior of a metal sheet

Biaxial Extension of Cruciform Specimens: Embedding Equilibrium Into Design and Constitutive Characterization

Experimental and numerical investigation of combined isotropic-kinematic hardening behavior of sheet metals

Tbiaxial Tension Test of Soft Materials

Large strain flow curve identification for sheet metals under complex stress states

Fundamental problem in optimizing the biaxial testing specimen

A novel mechanical attachment for biaxial tensile test: Application to formability evaluation for DP590 at different temperatures

Sheet metal forming limits under stretch-bending with anisotropic hardening

Simplified method to identify full von Mises stress-strain curve of structural metals

Theoretical failure investigation for sheet metals under hybrid stretch-bending loadings

Characterizing the Back Stress of Ultra-Thin Metallic Sheet Via Pre-Strain Tension/bending Process

Finite Element Modeling of Tensile Instability of Sheet Metals Considering Nonuniform Mechanical Properties

Characterizing the fracture forming limit curve from shear to uniaxial tension in ultrathin sheet metals using specimens with cutouts

A comprehensive solution to miniaturized tensile testing: Specimen geometry optimization and extraction of constitutive behaviors using inverse FEM procedure

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming