Abstract:High-temperature gas-cooled reactor (HTGR) nuclear power plants adopt an unpressurized vented confinement due to their inherent security. Negative-pressure exhaust systems (NPES) are therefore designed to maintain vacuum in the confinement so that radioactive gas and aerosol cannot pollute the atmosphere through exfiltration. For engineering applications, NPES should be shared by more than one cabin. The control strategy of NPES in the high-temperature reactor pebble bed module (HTR-PM), an HTGR demonstration project, is considered in this work. After describing the exhaust system with a mathematical model, a modular Simulink (R) simulation model is developed to aid in the design of the exhaust systems of HTGR nuclear power plants. Analysis of simulation results shows that (1) the volumes and airtightness of the cabins play dominant roles in the effectiveness of the control strategy. The time required to cut over between cases (time constant) can also affect effectiveness. (2) The control strategy of HTR-PM is effective, but when power plants increase in size, the control strategy becomes difficult to copy directly. (3) When an exhaust system with HTR-PM's control strategy is applied to serve only one cabin with standard air-tightness, its volume should be between 1300 and 46,000 m(3) to avoid misjudging accidents. (4) When an exhaust system with HTR-PM's control strategy is applied to serve two cabins with standard airtightness simultaneously, the cabins' volumes should be within the aforementioned range. (5) When three or more cabins with standard airtightness are served by one exhaust system simultaneously, the case can be simplified into the case with two cabins, and preliminary judgment of the effectiveness of HTR-PM's control strategy can be obtained. (6) Our Simulink (R) model can be applied to study cases in which airtightness and the control strategy vary. Therefore, this model can be applied in the design of NPES of HTGR nuclear power plants.

Design of the Exhaust System in the Confinement of the HTR-10

Design of Safety Subatmospheric Pressure Ventilation System for HTR-10

The design features of the HTR-10

The primary loop confinement and pressure boundary system of the HTR-10

Experimental Study on the Residual Heat Removal System in HTR-10

Thermal Hydraulic Instrumentation System of the HTR-10

Design and Tests for the HTR-10 Control Rod System

Pre-service Tightness Tests of HTR-10 Primary Loop Pressure Boundary System

Radiation sources and shielding design of process system for 10 MW high temperature gas-cooled test reactor

Simulation-aided Design of the Negative-Pressure Exhaust System in HTGR Nuclear Power Plants

Structural Design of Ceramic Internals of Htr-10

Licensing of the construction permit of the HTR-10

One implementation of vented low pressure containment for HTR

Dynamic Character and Operation ProcedureModel of 10MW High Temperature Gas-coOled Test Reactor

Two Phase Flow Stability in the HTR-10 Steam Generator

Three-dimensional Numerical Investigation of Heat Transfer Process in the Reactor Cavity of HTR-10

Htgr Projects in China

Design and Performance Test of the Helium Safety Valves for HTR-10

Radiation Protection Practices During the Helium Circulator Maintenance of the 10 MW High Temperature Gas-Cooled Reactor-Test Module (HTR-10)

Experimental design on performance improvement of the helium purification system of HTR 10

Experimental and Operational Verification of the HTR-10 Once-Through Steam Generator (SG): Heat-transfer and Hydrodynamic Features of the Once-Through Steam Generator