How do discharge rate and pipeline length influence the rheological properties of self-consolidating concrete after pumping?
Wenkai Shen,Qiang Yuan,Caijun Shi,Youhong Ji,Rong Zeng,Wei Li,Youwu Wu,Lilin Lao,Zheng Chen,Fumin Li
DOI: https://doi.org/10.1016/j.cemconcomp.2021.104231
IF: 9.93
2021-11-01
Cement and Concrete Composites
Abstract:Pumping changes the rheological properties, workability and construction performance of fresh concrete. However, there were limited knowledges on influences of discharge rates and pumping distances on the fresh properties of concrete. In this paper, effects of various discharge rates and pipeline lengths on rheological properties of self-consolidating concrete (SCC) after pumping were studied. A total of 12 SCC mixtures with the slump flow of 650–745 mm were pumped in pipelines with measured lengths of 342 m, 545 m, and 1044 m by constant discharge rates ranging between 5.1 and 11.4 L/s. Rheological properties were measured before and after pumping. Physical conditions of SCC during pumping, including pressure, shear, and temperature were estimated theoretically and experimentally. Moreover, the total organic carbon in the pore solution of SCC mixtures was measured to evaluate the change of superplasticizer adsorptions after pumping. Test results indicated that, due to pumping, the yield stress increased; the initial tangential viscosity decreased and the shear-thickening phenomenon was eliminated. The changes of yield stresses and viscosity were encouraged by discharge rates. Besides, lower initial slump flow of SCC exhibited a larger slump flow loss after pumping due to a higher shear rate experienced during pumping. The yield stress and viscosity after pumping increased with the increase of pipeline length at similar discharge rates, but decreased with the pipeline length under similar pumping pressures. The adsorption of superplasticizer increased after pumped at relative low discharge rates (5.2–5.7 L/s), but decreased at discharge rates of 7.7–10.8 L/s.
construction & building technology,materials science, composites