Abstract:A 61-MHz Pierce oscillator constructed in 0.35-<inline-formula> <tex-math notation="LaTeX">$\mu \text{m}$ </tex-math></inline-formula> CMOS technology and referenced to a polysilicon surface-micromachined capacitive-gap-transduced wine-glass disk resonator has achieved phase noise marks of −119 dBc/Hz at 1-kHz offset and −139 dBc/Hz at far-from-carrier offsets. When divided down to 13 MHz, this corresponds to −132 dBc/Hz at 1-kHz offset from the carrier and −152 dBc/Hz far-from-carrier, sufficient for mobile phone reference oscillator applications, using a single MEMS resonator, i.e., without the need to array multiple resonators. Key to achieving these marks is a Pierce-based circuit design that harnesses a MEMS-enabled input-to-output shunt capacitance more than <inline-formula> <tex-math notation="LaTeX">$100\times $ </tex-math></inline-formula> smaller than exhibited by macroscopic quartz crystals to enable enough negative resistance to instigate and sustain oscillation while consuming only <inline-formula> <tex-math notation="LaTeX">$78~\mu \text{W}$ </tex-math></inline-formula> of power—a reduction of <inline-formula> <tex-math notation="LaTeX">$\sim 4.5\times $ </tex-math></inline-formula> over previous work. Increasing the bias voltage of the resonator by 1.25 V further reduces power consumption to <inline-formula> <tex-math notation="LaTeX">$43~\mu \text{W}$ </tex-math></inline-formula> at the cost of only a few decibels in far-from-carrier phase noise. This oscillator achieves a 1-kHz-offset figure of merit (FOM) of −231 dB, which is now the best among published chip-scale oscillators to date. A complete linear circuit analysis quantifies the influence of resonator input-to-output shunt capacitance on power consumption and predicts further reductions in power consumption via reduction of electrode-to-resonator transducer gaps and bond pad sizes. The demonstrated phase noise and power consumption posted by this tiny MEMS-based oscillator are attractive as potential enablers for low-power “set-and-forget” autonomous sensor networks and embedded radios.

Design of Crystal Oscillator Chip with Low Power and High Stability

Study and design of an on chip clock generator with high stability

Design of a Crystal Oscillator Chip with High Stability and Wide Power Supply Range

Low-dropout regulator with no off-chip capacitor and ultra low power consumption

A Low Power Low Supply Sensitivity Current-Mode Relaxation Oscillator

A Low- Power CMOS Ring- Based Oscillator Using Current Steering Logic Structure

Reliability Enhancement Methods for Relaxation Oscillator with Delay Time Cancellation

Chip Scale Atomic Resonator Frequency Stabilization System with Ultra-Low Power Consumption for Optoelectronic Oscillators.

3.8 A 0.954nw 32khz Crystal Oscillator in 22nm CMOS with Gm-C-Based Current Injection Control

Design of Low Power Cmos Crystal Oscillator with Tuning Capacitors

A Chip-Scale Atomic Resonator-Based Stabilization System for Optoelectronic Oscillator

A fast and low power consumption crystal oscillator driving circuit design.

A 255nw 138khz RC Oscillator for Ultra-Low Power Applications

Low-Power MEMS-Based Pierce Oscillator Using a 61-MHz Capacitive-Gap Disk Resonator

A High-Precision Mixed-Signal Voltage-Controlled Crystal Oscillator with Temperature Compensation

Analysis and Design of 32.768khz Crystal Oscillator for RTC

A 0.72nw, 0.006mm2 32khz Crystal Oscillator with Adaptive Sub-Harmonic Pulse Injection from −40°C to 125°C in 22nm FDSOI

A Low-Power, Small Area and Low Manufacturing Cost Oscillator Circuit

A Power-Efficient Pulse-VCO for Chip-Scale Atomic Clock.

A 99nW 70.4kHz Resistive Frequency Locking On-Chip Oscillator with 27.4ppm/°C Temperature Stability

A Low Temperature Drift Coefficient Crystal-Less Frequency Reference Clock Compensated By Temperature Sensor For Microsystem