Abstract:Friction and lubrication are important parameters that affect the quality of sheet metal forming; excellent lubrication conditions and less harmful friction can reduce local thinning, delay fracture, and improve surface quality. Aiming at the poor friction conditions and difficult lubrication in the flange area during deep drawing, an active pressurized forced lubrication deep drawing (FLDD) process was proposed in this paper. A hydraulic system was employed to flush high-pressure lubricating oil into the contact gap between the die and sheet in the flange area. The high-pressure hydrostatic oil film in the contact gap can reduce the real contact area and effectively improve the lubrication conditions. The equipment is simple, the cost is low, and the lubricating oil pressure can be measured and controlled. Under the conditions of 20-kN, 35-kN, and 50-kN blank holder force (BHF), FLDD testing of box parts was carried out with 5-MPa and 9-MPa pressure using water-based lubricating oil. The horizontal comparison experiment was conducted with vegetable oil and water-based lubricating oil under the same process conditions. The test results illustrated that the lubrication effect of vegetable oil was the worst, whereas the lubrication effect of water-based mineral lubricant was significantly improved after pressurization. The maximum forming height was increased by 17.97%, the maximum forming force was reduced by 8.9%, the maximum wall thickness thinning rate was decreased by 7%, and the lubrication effect at 9-MPa pressure was superior to that of 5 MPa. The FLDD process has definite application value in improving the production environment, pollution control, and automatic production.

Deep Drawing Using a Novel Hydromechanical Tooling

The Study on Forming Principle in the Process of Hydro-Mechanical Reverse Deep Drawing with Axial Pushing Force for Cylindrical Cups

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Experiments for Novel Hydro-Mechanical Deep Drawing Die

Deep Drawing of Rectangle Parts Using Variable Blank Holder Force

The Reverse Deep Drawing with Hydraulic Counter Pressure and Its Numerical Simulation

Radial Lorentz Force Augmented Deep Drawing for Large Drawing Ratio Using a Novel Dual-Coil Electromagnetic Forming System

Improvement of Hydro-Mechanical Drawing Die and Process

Blank-Holder Force Control in Deep Drawing of Rectangular Parts of AZ31 Magnesium Alloy Sheet

Investigation on the design of hydraulic high-speed punching press with a large press force and a long press stroke

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Design, construction, and demonstration of a novel die system for deep drawing applications with utilization of ultrasonic vibrations

A Servo-Motor Driven Active Blank Holder Control System for Deep Drawing Process

Research on the active pressurized forced lubrication deep drawing process and evaluation of the lubrication effect

Lever mechanism application in the continuous drawing die

Experimental research on warm deep drawing of magnesium alloy sheet by variable blank holder force control

Research on the Critical Blank Holder Force of Elliptical Heads

Status and Development of Hydro-forming Deep Drawing of Cylinder Cups

Toward better metal flow control in electrohydraulic sheet forming by combining with electromagnetic approach

Incremental electromagnetic-assisted stamping (IEMAS) with radial magnetic pressure: A novel deep drawing method for forming aluminum alloy sheets

Process window calculation and pressure locus optimization in hydroforming of conical box with double concave cavities