Abstract:Blank holder force (BHF) is one of the important process parameters in the deep drawing process. BHF helps produce defect-free components by controlling metal flow during the deep drawing process. If BHF is low, it causes wrinkling; otherwise, it causes the sheet to rupture. Therefore, optimization of BHF is an important issue in industries. One of the effective approaches to determining optimal BHF is to study forming force, thickness distribution, and wrinkles to produce a deep-drawn cup. The main function of this approach is that it minimizes the maximum forming force and prevents process limits. Therefore, this study aims to investigate the relationship between the BHF and forming force through experimental and simulation results. In addition, the effect of BHF on the thickness distribution and wrinkling is considered. Hence, numerical and experimental methods were employed for St14 and SS304L sheets with thicknesses of 0.5, 1, and 1.5 mm to achieve the objectives. Firstly, the simulation of the process was performed to study the mechanical behavior. Then, a set of experimental tests were conducted to validate the simulations. Finally, utilizing the experimental and numerical results, the optimal BHF value was determined. It was observed that the maximum thinning and maximum forming force are related to the forming process without BHF. Moreover, when the wrinkling at the edge of the part was removed by gradually increasing BHF, the minimum values of forming force and thinning were obtained. According to the investigations carried out on three thicknesses, it was observed that by reducing the thickness from 1.5 to 0.5 mm, the maximum forming force decreases in both SS304L and St14 sheets. However, the acquired results showed that the minimum optimal BHF is obtained in both sheets at a thickness of 1.5 mm. Overall, this research provides valuable experimental and numerical guidance for implementing the deep drawing process to manufacture cylindrical parts with minimum forming force required to save energy consumption.

Blank-Holder Force Control in Deep Drawing of Rectangular Parts of AZ31 Magnesium Alloy Sheet

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Research on the Critical Blank Holder Force of Elliptical Heads

Development of forming process for deep drawing of square cup with optimized blank holder pressure

Experimental and numerical investigation to determine the optimal blank-holder force in deep drawing process based on forming force for SS304L and St14 sheets

Study on Calculation of Black Holder Force in Deep-Drawing Rectangle

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

FEM Simulation on New Deep Drawing Process to Blank with Technique Holes

Radial Lorentz Force Augmented Deep Drawing for Large Drawing Ratio Using a Novel Dual-Coil Electromagnetic Forming System

Effect of process parameters on the deep drawing formability of aluminum and advanced high-strength steel square cups

A New Equation of Load Curve of Critical Wrinkles Variable Blank Holder Force in the Warm Deep-Drawing of Twin-Roll Cast Mg Sheets

Numerical multi-objective optimization of segmented and variable blank holder force trajectories in deep drawing based on DNN-GA-MCS strategy

Numerical Simulation of Hot Stamping Forming of AZ Series Magnesium Alloys and Optimization of Die Process

Design and Application of a Novel Cone-shaped Blank Holder for Precision Stamping Process

Study on intelligent control technology for the deep drawing of an axi-symmetric shell part

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Study on Optimized Control of BHF

Finite element simulation and experimental study of non-blank holder forward and backward composite deep drawing earing test

Experimental Research on Formability of Stamping of AZ31B Magnesium Alloy Sheets

Optimization of Processing Parameters of Aluminum Alloy Cylindrical Parts Based on Response Surface Method during Hydromechanical Deep Drawing