Abstract:Variations in planar fault energies, generated by changes in alloy composition, can influence thermally activated processes which govern plasticity in intermetallic alloys. Predicting variations in defect energy as a function of alloy composition would aid both alloy design and the interrogation of models of yield stress. In this paper, layered Korringa-Kohn-Rostoker coherent potential approximation calculations are reported for the superlattice intrinsic stacking fault (SISF) and antiphase-boundary (APB) energies in binary and ternary Ti-Al alloys. The planar fault energies were calculated over a range of alloy composition: (Ti1−xAlx)1−y My with 0·48 ≤ × ≤ 0·51, 0·00 ≤ y ≤ 0·02 and M = Cr, NB. For the Ti-rich alloys, ternary additions up to 4at.% were also considered. APB (010) energies were calculated for the binary alloy while the SISF and APB (111) energies were calculated for all the binary and ternary alloys. The compositions Ti50Al50 and (Ti50Al50)1−yCry have the maximum defect energies for this range of alloy compositions. Cr additions appear to have little influence on the defect energies of the Ti-rich alloys, while slightly reducing the APB (111) in the Al-rich alloys. The defect energies for the Nb alloys are reduced relative to the binary alloys, with the fault energies increasing monotonically with increasing Al concentration. The variation in defect energies, both trends and magnitude, are used with anisotropic elasticity theory to estimate the forces needed to produce two possible 〈101]{111} superdislocation glide barriers. Also, the anisotropic elastic energy of the nonplanar equilibrium superdislocations are compared. The formation of 〈101] {111} superdislocations with portions on cross-slip octahedral planes is favoured over cross-slip onto the cube plane for conservative estimates of the planar fault energies and applied stress. These results suggest that alloy designers can expect only moderate improvements in the high-temperature yield stress, because of the formation of 〈101] {111} superdislocation barriers, with changes in alloy composition.

Stability Of A Planar-Defect Structure Of The Wurtzite Aln (10(1)Over-Bar0) Surface: Density Functional Study

Stability of a Planar-Defect Structure of the Wurtzite AlN(101¯0)surface: Density Functional Study

Absolute Surface Energies of Wurtzite (101¯1) Surfaces and the Instability of the Cation-Adsorbed Surfaces of II–VI Semiconductors

First Principle Study of the Native Defects in Hexagonal Aluminum Nitride

Research on the Stability of Different Polar Surfaces in Aluminum Nitride Single Crystals

Structural Characteristics, Stability, and Electronic Properties of 001 Surface with Point Defects of Zinc Stannate: A First-Principle Study

Effects of Surface Defects on Two-Dimensional Electron Gas at NdAlO3/SrTiO3 Interface

Stability of FeAl(110) Alloy Surface Structures: a First-Principles Study

Structures of CoAl(1 1 1) surface: A first principles study

Regulate chemical environment to control the formation of defects on Ta<sub>3</sub>N<sub>5</sub> (110) surface: From theoretical perspectives

Strain Induced Defect Superstructure on the Surface

First-principle study on the effect of point defects on the mechanical properties, thermal conductivity, and optical properties of wurtzite AlN

Structural and Electronic Properties of the Adsorption of Oxygen on AlN (101̅0) and (112̅0) Surfaces: A First-Principles Study

Exploring electronic properties, surface energies and cleavage energies of low-Index surfaces of AlB 2 by first-principles calculation

Surface Structure and Stability of PdZn and PtZn Alloys: Density-functional Slab Model Studies

From the absolute surface energy to the stabilization mechanism of high index polar surface in wurtzite structure: The case of ZnO

Planar fault energies and sessile dislocation configurations in substitutionally disordered Ti-Al with Nb and Cr ternary additions

The Structure And Electronic Properties Of Aln/Srtio3 (111) Interfaces

Asymmetry of Adsorption of Oxygen at Wurtzite AlN (0001) And(0001¯)surfaces: First-principles Calculations

Defect structure of high temperature hydride vapor phase epitaxy–grown epitaxial (0 0 0 1) AlN/sapphire using growth mode modification process

Theoretical Study of the Stabilization Mechanisms of the Different Stable Oxygen Incorporated (101¯) Surface of III-nitrides